Відео

If your gas safe and have done your course, all appliances need to be tested at max and minimum rates

This is an old video 👍

Please contact a plumber as they will be able to help you

I’ll be honest with you that was a long time ago now, I can’t fully remember

@snapgas9832 no I understand. I looked at the baxi 80e boiler today, they have hot water only when heating is on, but no hot water without the heating. Any idea?

Think it’s 32mm mate

Yeah mate very easily done! Spend ages looking for something that was right infront of you, cheers for watching

Hi mate, yeah the heat exchanger will just come literally as that, With regards to how they refit back in after I normally would order up new seals for them bits and grease them up Failing that I would just really grease them up and see how it goes

Apologies mate I’ll ditch those then 😂

I work for a company mate, but actually trying to move into management now as getting a bit older and fed up of driving around 😂

Cheers toddo

Cheers mate, no I left that coming up to a year ago mate

Thank you mate! Will be more coming

Appreciate that mate

Hello mate, I will look into this now. I’ve been to plenty for British Gas, would get them weekly

@ if you could that be great. They mentioned it when I done my last assessment.

Ya left shitish gas pal

It's true, you're supposed to be qualified to do a proper assessment. I get them every so often (social housing), I "check out" the appliances, change the CO alarm. And give them ventilation / evacuation instructions and fuck off. It's always been faulty alarms, but sending untrained people is a cop out.

I had this last week, if you follow the chart in igem11 it says if you are happy to turn back on do so but if not escalate to someone with CMDDA1.. in December gas safety mag there is a question asking if you need cmdda1 to investigate an alarm, their reply says no.

Thank you mate

Thank you mate! Hope it’s useful

Absolutely cheers I will do them

Wish we had that option mate but unfortunately we don’t, but there’s a lot to keep on top of with unsafe situations etc

Think it’s a great idea

How can you not see what is being adjusted? There are close ups of it….. Also this is for gas safe engineers to do

Yeah I think alot of different boilers have this issue, I had it on a Baxi solo aswell with the door seals and the sump seals blowing onto the overheat stat on the fan Cheers for watching

If you don’t know I’m not sure your gas safe, please get a gas safe engineer to help you

This was my first few videos and was extremely nervous, apologies

Ok thanks for that, not sure what all that means but appreciate your comment

Please contact a gas safe engineer

Apologies was 1 of my first videos and was very nervous

Glad you liked it

Wd40 or something similar gt86 for example

Glad it was helpful!

It could do as they have the square type of heat exchanger, I had it on an old cdi the gasket at the front had gone and was blowing heat to the over heat stat next to it

True this can happen

Thanks Greg

Yeah mate they did, and yes you are right! Reason I put this video out was that it stumped me and couldn’t work out why it was showing over heat with no sign of the boiler over heating! Everydays a school day in this game

@@snapgas9832 yeh some good videos mate started watching through them and followed! As you say every day a school day

Hi, what I found was there multiple blockages and was unable to clear them from memory

Open vent, 3 port, new pump 🫠

Not necessarily mate, could be that the gas valve needs adjusting Or could be the heat exchanger is blocked up etc