Відео

How to hard reset SPRO IP camera | forgot password

After a very hot summer my car phone mount/holder slid down the windscreen leaving a trail of gluey residue. I didn’t think much of it until my car failed its MOT due to it. I was trying to remove the residue using “sticky stuff remover” and a scraper but to no avail until I tried a few drops of Ethyl acetate which cut through it in seconds without any problems. I make these videos not as a sub...

A quick video on how to install or replace check straps on your door for a Ford Transit MK7 van.

In this short video I show you how to configure IdeaMaker profiles for 3d belt printers such as the CR-30 (3DPrintMill), SainSmart INFI-20, etc.

This is a short video on how I gained access to my fuel after my fuel door became stuck. This issue appears to be common with Jaguars of this age and tends to happen around winter. The trick is to slowly create a gap at the top of the door and then slide off the cover towards the rear of the car. This will give you access to the underneath mechanism. You can do what I did and then spray the who...

The Elite Direto X currently being sold at Halfords is a great purchase for the price.

This is the video that comes supplied with the CR-30 / Naomi Wu's 3DPrintMill

Here’s a quick and easy tip on how to insert the smooth rods into the printed parts for the x-axis on a prusa MK3, MK3S or MK3S . A lot of people have suggested using a 5/16 drill bit but that seemed risky to me. I also didn’t like the idea of hammering the rods in so I just put them on my cordless drill and slowly screwed them in. It worked perfectly and took seconds. I set the drill to a low ...

A quick little video on how to remove the PTFE tube from the hotend on a Creality 3D printer - particularly one of the Ender 3 series printers. If you are watching this video it's probably because like me your PTFE tube wouldn't come out of the hotend. I initially tried heating the hotend and pulling the coupling and PTFE tube out but it just wouldn't come out. I then dismantled the hotend whic...

A brief guide on how to install 25mm yellow springs on your Creality Ender 3 V2 printer.

This is the video from Creality 3D that is provided on the SD card that comes supplied with every new Ender 3 V2 printer.

So this is a slightly updated video than my last one. Before installing your glass bed read this! The Ender 3 Pro comes supplied with a magnetic build surface. If you're upgrading to a glass bed be sure to remove the magnetised surface from the heated element before installing your glass bed (not just remove the removeable magnetic bed like I previously did). You can do this by heating the bed ...

Noisy MacBook Air video 2

Noisy MacBook Air video 1

How to install glass bed on Creality Ender 3 Pro 3D printer

Quick review of the Ryobi Caulking Gun (2020)

Ender 3 Pro: Fixing bad prints

BIGTREETECH SKR MINI E3 V2.0

How to open / access Ender 3 Pro mainboard

Step by Step Guide: How to assemble Creality Ender 3 Pro

Eufy RoboVac 15C Max - BoostIQ mode

How to remove Lath and Plaster ceiling

2019 LEXMOTO VALIANT EFI Exhaust note / sound 🎵