- 12
- 105 670
louis2103
Приєднався 27 сер 2006
Відео
Vkar Bison V2 120A RTR reverse steering shake
Переглядів 1335 років тому
MODEL : Vkar bison v2 120A esc Awesome truggy. Very nice build. This is maiden run. Found that when go REVERSE, the steering were shaking at some point even no input from transmitter. I tried many round to calibrate the throttle range and servo trim but still same. Please help to comment if any solution for this.. Thank you.
Hisky HCP100S tail rotor stop working
Переглядів 1507 років тому
Hisky HCP100S tail rotor stop working suddenly. Not sure it's esc or tail motor problem. Please help me to decide which part to purchase to avoid waste of time/money. TQ
Overdrive active capacitive stylus malfunction.
Переглядів 3547 років тому
Overdrive active capacitive stylus malfunction. Replace with fresh new battery. The button just can't turn on after the device been turn off.. Hope overdrive dealer will help me out on this Thank you.
Novatek 96650 G30 DVR 1080P faulty
Переглядів 1,1 тис.8 років тому
Novatek 96650 G30 DVR Purchase from Banggood around March 2015. All the while was serve good and capture and good quality video with the price paid. However, it just suddenly start malfunction unable to record and hang on the screen whenever you press on start recording. Refer above video. Before Starr recording, time stamp is operate as normal while once press the start recording, the DVR just...
Proton Inspira 4B11 2.0P Weird Knocking/Valve noise During Idle
Переглядів 3,5 тис.8 років тому
Please skip to 00.29 onward if want to zoom in the purpose of this video. The sound refered (Either Knocking or Valve Noise) ON & OFF come from engine bay. been checked before at Service Center was suspecting 1) Solenoid Valve 2) Purse Valve but both did replace before and didn't solve the issue. last item suspect is "CANISTER TANK" but the Service center (SC) didn't help me replace to test due...
Proton Inspira 2.0P CVT Gearbox Whinning Part 2
Переглядів 7 тис.8 років тому
Proton Inspira 2.0P 2013 Model Millage Recorded approx 57.5K km Whining Noise that occur once engine temperature reach optimum or whenever put engine with some load (uphill road condition will be more Noticeable) CVT J4 Fluid change at 40k km at Proton Service Center & CVT gearbox been whinning much louder start 53k km. been check round and round again at Proton Service Center since 2 months ag...
Proton inspira 2.0 CVT gearbox whinning Noise
Переглядів 15 тис.8 років тому
Whinning Noise that occur once engine temperature reach optimum or whenever put engine with some load (uphill road conditon) Inspira 2013 cvt 2.0P model Millage record approx 55,000 km
I Charger 106B+ Balancer Port Faulty
Переглядів 11610 років тому
Was using this charger since last half year working great from hobbyking.com. only since last week the balancer port especially for 3 cell was faulty.. whenever plug in 3cell lipo battery, in cell monitor will appear 4th cell approx 0.50~0.75volt. these make the charger unable to detect proper cell count to proceed balance charge for all my 3 cell battery. tested many pack of 3 cell battery aro...
You have to invest in a decent pen and clean it with ipa regularly
Mine doesn't turn on
Your instruction videos was wonderful. NOTTT. WHY DID YOU WASTE YOUR TIME. Cat got your tongue?
Same with mine …..is not reading
The water temperature must be 25°c?
This is so stupid i paid 15 bucks for a fking metter that i have to do all this bs to
Then,pay $80-$100+ for,one you ALSO have to do this to!😊
@@Mizman76but it will last longer
Don't loose the press until the reading stopped blinking that's your wrong process
Here watching videos before I try this thing and this is what I'm seeing
Use warm water, should work.
normal with this china trash
Bisakah alat ini untuk ngukur ph urine
silent videos mean your too dam lazy to talk!
Im having issues with one that looks the same. Did you solve it? Manual says to soak the tip in the liquid for a few hours... trying that now.
Didn’t solve. End up give up already
Hold calibration button for 5 full seconds.
Kereta bro problem dah solve ker? Kereta saya baru jadi tadi time climb bukit (rpm tinggi) tapi logo cvt heat TAK KELUAR kt meter. Pls advise
Video quite sometime ago. Once cvt get hot, will whine. So to prevent it overheat. Few thing I maintain, 1) add 1 cvt cooler 2) every 30-40k km will change cvt fluid. Top filter and at least service bottom filter or change it. So far had around 260k km done. No cvt issue yet. Touch wood
@@louis2103 thanks bro. So this is a common problem for 4b engine. How much the cost to install a cvt cooler?
@@syafrizalafif1334 common for cvt gearbox.. need treat gently. 🤭 Forget the price of cooler. But it was done more than 5 year ago maybe around 400
Apa problem bos
Mine will only calibrate to 6.86 but when try to calibrate 4.0 it will display 6.86 again can’t get It to go on to the next cal ph4.0
Same 😢
Fast press cal after holding for 5 seconds
My phone testers same problems
Unit faulty then. CAnt be calibrated
Transmission oil degraded,change it together with filter and reset cvt degradation.
full service dekat jtech autoserv pakai j4 rm620.. hrap membantu
Important!!! Or not but i just got a new one today and used purified drinking water (not sure if wrong) for the packets at 250ml and I would get the error when trying to calibrate the 4.01 ph one and wouldnt go away unless i removed the battery, but then I calibrated the other two packets with acurate reading and tested the 4.01 ph and it was at 3 ph so!!!! **I think if you try to calibrate without the correct ph lvl you might get the error code.
I sprayed the glass bulb with Isopropyl Alcohol (IPA) and soaked the end in hot tap water (as hot as your faucet has), blasted with IPA again, gently scrubbed the glass bulb with a boar's hair shaving brush and rinsed the tip and bulb in hot water. After I dried the tip off I soaked the end in distilled water and was able to calibrate the PH meter. Dried gunk gets built up on the glass bulb especially if the meter is used for measuring PH of hydroponic solutions which have dissolved salts, etc in the solution.
I think the electrode has been dried out... souck it in distilled water for a few hours.
Mines start at 1600 it's no 0000 why is that
it is normal.
Same pen same issues . Even with new batteries i think this pen is a peice of junk going off how many people have the same issue
Haha.. Low quality perharps..
Same here, I’m only being offered a refund. I tried the take the battery out and it still doesn’t work. I even tried soaking it in distilled water and still no luck!
I guess it's one of the defect issue. Duno why these item so fragile.
Ni bunyi apa.. Masalah yg sama sya hadapi.. Mcm mana nak settle masalah ni
Tak dapat solve. I leave it there till today. On n off mari. But tak kacau so far touch wood
@@louis2103 dh dpt solve blm?
@@shahbasir7 no bro. Live with it. Since no one can confirm which part to touch up. And doesn't harm me so far.
mine also..weird thing..when open hood,the sound is not there..but when seat inside,we can hear it..when i on aircond,the sound is gone
@@shahbasir7 that's the hardest part for mechanic to diagnos the exact issue where it came from. That's why no ppl can tell it. But since car didn't make any issue. Just use it. 🤣🤣
Replace with new motor or rewinding tail motor
Had get a new motor. Still not solve. Guess either is esc or main board problem. Not worth try an error anymore. Cox both esc n main board part cost the near the new heli. :(
Jika seperti itu permasalannya.. ya...lebih baik beli heli yang baru. new rc heli right.....
@@jafarsidik180 ya bro. Tat y now keep it as display saja. Haha. Extra tail motor new unused. Wait member c yang crash dapat part murah baru repair. I rasa is tail esc failure.
mine did same thing ...remove the battery to reset and then try it again...mine worked!
como se resetea?
same shitty amazon ph pen lol
Engine inspira bukan sama dgn mitsubishi lancer ke?
Safrinism sama
Kalau mcmtu macam mana pulak boleh ada problem, kalau mcmtu orang proton la pasang tu buat jadi masalah
Safrinism entah bro. But the problem of this noise gone after I get someone good in this mechanic service the gearbox. So far so good..
@@louis2103 wow boleh share ke siapa orang tu? Probaly di pun pakar dlm gearbox cvt proton? Kalau ingat location dia?
Safrinism jTech Auto Service near jln pudu. Dia service banyak gearbox for inspira and Nissan cvt. so far I full service je hilang sound. Do nothing special. Proton SC full service wasted my money nothing cure.
Don't put neutral gear when you stop at traffic light,just stay at D,hold your brake,when light turn to green just gas the throttle..the CVT transmission need to be like this..
Buknkh klu letak D akn ganggu clutch CVT
@@name6440 bodoh inspirate owner ni jwblh dlm english😂level capyam
prove it? dont just talk talk and diassapear
Have the same issue with mine😐
Hi louis. I also had the same prob as yours. Really glad that u are able to fix such prob. Just want to ask u, whether u able to drive again your car till 170km/hour++ after that servis? Is the noise still there? Thnx again for giving me hope that i don need to change all the gearbox. Huhu.
mohd noor azam mohd nazri hi, I very rare drive till 170km++ Usually was stable speed 140-150km/h And no sound. Now I practice to replace cvt oil every 30k km.
louis2103 bro, my car has the same sound as urs. How much u fix at there? Izit the one near Pudu there?
Goh Cheng yes. Near pudu.
@@louis2103 how much does it cost ya?
Total cost do full service was about 600
Changing the fluid & top/bottom filter plus fully flush the cvt oil.then it gone. Been done the same on proton can’t solve but do at outside JTech Auto service then it magically solved
How much it cost sir?
hi louis , did you get it fix ?
Calibrate your esc read your instructions to help you out on how to. I had the same problem before then I did the recalibration and it fixed the issue and I also gained 1mph top speed and feels much more precise on controls.
Jacquez E Balcazar calibration of esc throttle range had been done before. What else calibration can do at esc? Shall try to recalibrate again c if works.
Maybe try a Flysky fs-gt3b receiver transmitter combo for $32.
I have the same problem with mine. When reversing, the steering goes crazy but when forward it's totally normal. Have you found the problem why?
oscar mendez still no solution yet. I tried to send this video to seller but they said normal. No choice but I have to try an error. Had order the more powerful servo to try it out. Waiting shipment. Hope it's just servo from my observations.
@@louis2103 yes it seems like the servo is malfunctioning. I'm gonna do the same and put a new one in. Thanks for the response.
oscar mendez mosty probably will be servo I guess. Either is malfunction or else is underspec. The servo not strong enough to hold in straight line. Therefore, need a higher spec servo which can carry more kg. (Just my point of view, still need test out for the answer)
definitely CVT. mine have no issues even after long(20-30mins) 170kmh cruising, still smooth. my friend have similar issue, but his car only make that noise after high speed(120kmh) cruising for more than 5 mins, and theres slow down warning. after change to EXN CVT fluid, no more whine..
blitzer25 blitz . Ya it’s cvt for sure. Mine go and did the full cvt service at experience workshop and the sound gone now. Previous did full service it at proton service center but noise still there. Duno they got do it correctly or not
Full service meaning flush all cvt fluid, change top and bottom filter and new oil. Proton did but noise there. Outside did then all sound gone.. 😂😂
@@louis2103 how much does it cost for all those service?
Maybe noise from compressor
Same Issue for me also... Any solution or fix ?
I have the same problem here! anyone found out what's the issue? thanks.
The seller sent me the new unit after seen this video.
Shit exactly same here.
The same with mine and same pen too, Did you sort out? what should be done?
Did you ever sort out the problem? or did you chuck it?
exactly the same with mine and same pen too
I have mitsubishi outlander sport 2016 with same engine. Sounds like that. It visible when idle. Especially when you're seating in the car. But when you out from the car sounds hardly to hear. This engine is pretty noisy...
Jambangan I leave it the issue. But the whining sound gone after I found a good mechanic to service my cvt gearbox.
@@louis2103 where is ur mech located ?
demonhill the one who magically solve my issue mechanic shop is JTech Auto Service.
@@louis2103 thanks for your mech shop
Rawangggg
Didn't heard it
Elliot J Vidal may need use ur earphone to heard more clearly.
Thanks it workout with headphones I have that problem on mine now is summer and is hot here , Im Assuming the Transmission fluid I put on it cant handle the temperature , so also I think I have a little bit more Fluid of the one required , so IM gonna take some out and see how it goes. I have heard is a safe-mode thing the transmission make for not to get hurt , when the fluid is way to hot
OK. Mine reduce after change oil. But still there. Been let it till now. Touch wood still working.
I figure-out it have a Transmission Radiator , and it also use an Specific Radiator Fluid for Transmission , so Im gonna try replacing that and the fluid and see what happens , I already change fluid but not the Exactly one they suggest so lets see whats next
Elliot J Vidal transmitter radiator? The cooler is it? It's joint together with gearbox if u talk about trans cooler. So what u use for gearbox will circulate to that cooler as well.