- 5
- 10 814
Charles Ross
Приєднався 31 тра 2012
De-Crimping 556 Brass
Using the Dillon loader primer punch assembly modified to de-crimp 556 brass
Переглядів: 31
Відео
Making 300 Ham'r Brass
Переглядів 10 тис.4 роки тому
This video shows how to convert 5.56 / .223 brass to the new 300 Ham'r.
Dillon 650 & 300 Black Shell Disk
Переглядів 404 роки тому
Shows how to modify a Dillon 650 shell disk to properly dispense the 300 Blackout
Sky Dive
Переглядів 515 років тому
My first sky dive in tandem on 05-19-19. Statesboro GA airport The Jump Place
Dillon 650 Powder Check Problems
Переглядів 1,2 тис.6 років тому
Repairs and mods to Dillon 650 powder check system
That's exactly 💯💪. Thanks Again
I find that I don't have to treat HAM'R brass like 300B brass. Meaning that I don't use my HF cutter. I first take clean and lubbed (outside and inside the neck) 223 brass and immediately resize it in the 300H die. I go slow on the first resize, then give the case a ⅓ turn and resize it again. Using LC brass, I've so far only had one neck split. Then I trim in a Little Crow 300B trimmer that was reset with a fully processed 300H brass. It works perfectly. Zero issues. My brass trims at 1.595 (+/- .002). Very consistent. Once it's trimmed, I then chamfer, debur, clean the flash hole, primer pocket, and then drop it in a 300 HAM'R case guage. It's beautiful!
So your using a 300blk sizing die to form the shoulder. ???
LMAO
Well all i have to say is that was as confusing as anyone could make it .
So, in other words your making .300AAC Blackout cases??? Looking at the SAAMI specs, there's quite a difference where the shoulder is, but you don't tell us where to set the sizing die to get the proper height of the shoulder...
LEE makes 300 HAMR dies. He is using the 300 AAC Dillon Trimmer.
Good stuff big dog, I appreciate your know how
Thank you!
I'm thinking he meant ⚒ since thats the title of the vid
300 hammer or blackout?
Did you size it in the LEE to 300BLK??? That's what you said anyhow.
No he is creating .300HAM'R. As he said, his measurement of case length is 1.603 when the length of the .300BO case is 1.368. It's easy to cross up the names when have so many rolling around in the mind.
@@RideForLifeCR250R He might have changed 223/556 to blackout then to HAM'r if you pay attention to his wording and where/when he says blackout because maybe somewhere in the process of getting the 300HAMR it is cut or shaped like the 300BLACKOUT
All I need to make excellent 300 HAM'R brass is the Lee 300 HAM'R die set and a Little Crow 300 BLACKOUT trimmer. I set the trimmer to 1.595" and it works perfectly. I then finish processing the brass as you would any rifle brass. I don't use my HF cutting wheel at all in the process.
@@The10thManRules make a video please
Way to go Dad!