Відео

It was the hammer drill that killed the vibe

Next time have your helper put a little bit of tension on the jet line.

I’m not sure about that!!!!😮

ua-cam.com/video/FzjEaS4al-o/v-deo.html ✅✅

We make this head as a last resort for pulls greater than 300 ft (often underground) or raceways which have over 360 degrees. Often with larger wire, at least 10's or greater, and absolutely packed raceways (over 50%) fill where the half hitch method adds too great a diameter to the pull. It works, and to be fair, this works best with bigger wire. I've seen kellum grips fail, I've seen half hitch method fail; fingers and crimps are good too. This is the old school on the fly method when no other equipment is available for you.

About how many inches apart do you stagger each wire?

Nice!

Thank you

This method is if you don't have kellum grips, crimped heads, fingers and like.

Yikes

Nice try kid.

ua-cam.com/video/FzjEaS4al-o/v-deo.html

Buy pulling tape conduit all sizes with eye splice at www.rightrope.com. Save 5% on your purchase by using the coupon: Reb5

This method wouldn’t be accurate on big diameter tubes - 4 or 6 inch tubes. You need much wider tape than just a tape measure. Have you seen my video on You Tube?

The way he rotates the electric tape 😂

that could be a lot tighter and nicer.

That's not a fish tape... Thats pulling string.. Also called jet line. But the method was helpful

Woah

Striping wires: Putting stripes on them. Stripping wires: removing the covering from them. The difference is big!

Wear your gloves

Was that drill on hammer??

Made it harder then it needed to be

slip knot is about 157x faster and efficient

Awesome video guys! Keep it up!

Agreed! Parkway's at it again with the helpful tips.

what type of knot is in the fish tape?