Відео

Thank you Brother Kevin, this setting worked for my Malibu. Thank you for your time in making this video!

Needed this vid!!

Thank you Sir.

Can you work on one of these in the Stow position which would give full access to the underside of the mower?

Those lines your talking about are roller laps it's when you roll back into the part that already has a coat of bed liner on it making the product thicker in those places.

Thank you I couldn’t find another video that show how to fix it

How’s it holding up?

Thanks! My Toro lost power drive with about 15 feet left on my lawn. I thought it had jumped off or jammed on the "clutch" end of the mechanism, but couldnt figure out how to get to it to fix it. You gave me the information and its running great now. Thanks again.

I have a 2006 version of this van just had the same code you have to take the center console out? I thought it was glued on i may just have a mechanic do it

How do you tighten the belt on this type of mower?

I feel like the R86212 IS WEAKER THAN R86211

Drawing in the manual looks like the cable setup for AWD self propel

How many sensors has?

Whats the name of this product I am interested

You are my hero for this damn video lol. Made my life easier, which is the best thing in the world.

That stinks its not a bad tool must of got a dud it happens, i dont have one myself i have the Dewalt 900 but a buddy has it works great

great video-- I followed some other video and got the part from Amazon, but the belt was too tight to go on both pulleys - this video clearly explained how you can do it... thanks

Thank you!

شكراً لك ❤

Thank you

The before cleaning one looked still good for use, it doesn't seem like it would have a significantly higher pressure drop than the cleaned one. Was it reducing pressure?

Ok, here is some critical information, for those of us, with an electric/pull start system, and the black battery box on the deck of the mower. Ok, YES, there is a bolt underneath the box. But, it is towards the back of the mower, and you will see a slightly raised section of the box, that does not touch the deck, but sit's above it, about 1/4-3/8". The bolt you have to access is, literally in that notch, towards the backside of the black box/mower. And, I have found, that the box is riveted to the deck. So, for full access, you will have to rip the box off of the top of the deck, revealing 2 of the 3 bolts, as the 2nd bolt is, along the left side of the black battery box, just underneath the side front corner. But, if you are able to remove all of the plastic covers off of the back, including the flapper, for the bag. As, the top of the flapper for the bag hatch, is literally what has you blinded from seeing the bolt in the first place, besides the battery box itself. And, since I can't start it with the key anymore(Long story short, the cable harness was ripped out of the key starter switch, and ruined it), so it's pretty useless to me, at the moment. So, I decided to just rip the black box itself off. Which, made it much more simpler to access all 3 bolt's, for the plastic belt guard underneath. Also, it is a good idea to take a plastic bag(Walmart bags will do fine), and use it underneath the gas cap, by taking the cap off, then draping the bag(Double layer, by using whole bag) over the open hole, then screw the cap back on, and you now have a sealed gas cap, from leaking...

Word of advice, to not have to fight with that spacer, just use a bit of grease on the backside, that is closest to the blade, as it act's as a suction cup, to hold it in place. While, not making it a permanent fix to the bottom of the cylinder it sit's in...

That was fucking useless

I always use more, than less, like you. Heavier the coat, I think it lasts longer

Thanks Kevin. When I Doordash or uber, some of the instructions are please don't ring doorbell or knock. But my freakin car sure will freaking honk twice when I get out smh😂

I am thinking of lining and end dump semi trailer with this. What do you think??

I have one just like it. It didn’t come with instructions. I’m having trouble how to put the water in it.

Thank you! I've watched around 20 videos with people saying "be sure to release the pressure" and then saying or showing where the valve was. You're the best.

That was very helpful. Have new belt and new blade going on my 4 yr old Toro PP Lawnmower. Am sure I could have figured it out, but like the way you didn't have to take rear wheels off.. Probably not a bad idea anyway to grease those gears up. Now, if you can figure out how to keep from wearing out a $60 grass catcher, that would be nice. They last about 2 years for me.

Thanks for the info. Been having this issue and now i need to pass smog to register the damn truck 🤦‍♂️

TOUCHDOWN!!!!!!! Thank u real good😊

nice job!

Is there a way to adjust the belt. I bought a new one because the existing one was lose, installed the new one but still seems lose to me

just replaced the belt on my Toro Personal Pace lawn mower with the help of this video, lawn mower is back up and running again..thank you for the very helpful video!!

I've owned this same mower since 2015 and the blade shouldn't fit like that on it's holder. It shouldn't be twisted. That whole blade holder and pulley has been jacked around with. Very strange looking and possibly dangerous.

Great DIY video. Looks like the extra texturing came from your overlap rather than a clump.

I don’t own this exact model, but someone stole the design from someone. I have the Briggs and Stratton version of this design. Thanks for the video.

Thanks for the video! These lawnmower videos have really helped. Some of your up close shots are great. The belt isn’t my problem, but still helpful. My personal pace quit working, too. Looks like that black bracket on the gear box that the spring on the end of the cable is attached to isn’t attached anymore. Looks like the bracket is the only thing moving when I move the handle, not good. Going to have to find another video to see how the bracket attaches to the trans and why mine isn’t attached anymore. Thanks, again!

Very helpful

Thank you, perfect video!👍

Thank You! Very helpful.

Worked for my 2024 Colorado!

Can a guy use paint thinner instead of acetone to wipe the bed of the truck clean

i can feel the vibration💀

Looks nice well done my brother I will start my own soon

Thank you!!

Good thing about Rigid is that they have a lifetime warranty

Short simple and straight to the point.

Mine is still in the box ! Start building soon .