Professional handyman to tackle your home and office technical tasks. From plumbing, electrical, remote controls, gate motors, alarm systems. No job is too small
PROGRAMMING 1 - Run Time (Calibrating) Setup (With total power up, AC and DC, on PCB) • Unlock and open the override lever on the gearbox. • Open the gate manually approximately Imetre. . Close and lock the override lever on the gearbox. (PCB should beep 1-5 beeps pending on load pot setting) • Pull the gate in any direction until the gear locks in. • With all dipswitches OFF (excluding dipswitch 2 depending on motor direction), press & release the TEST/SET button. • Gate will close, open and close again and stop on close limit. (Motor speed can be increased during programming cycle by pushing and holding down the TEST/SET button, but release the button approximately 500mm before the close and open position). The final closing cycle of programming will automatically run at normal speed. • Control card will beep twice to confirm end of program run time (calibrating) setup. NOTE: 1) If gate opens first, dipswitch number 2 is wrongly selected. 2) Gate will automatically calibrate every time the power is restored after a total power failure, irrespective of present dipswitch selection. 3) The controller will drive the gate approximately 6mm past the closed limit activation position. Allowance must be made for this when setting the limit actuators.
Yo bro, it seems like I set the remotes but when I press the buttons it just flashes green, but no movement
I have same gate motor won't open or close only beeping when I press remote.
Check your fuses.
Please help me to program dts 500 gate motor
Look for the manual online
Hi
Bros using a Greece gun
Where does the battery wires connect
On th PC Board
Hi , can you help with how to set limits ?
PROGRAMMING 1 - Run Time (Calibrating) Setup (With total power up, AC and DC, on PCB) • Unlock and open the override lever on the gearbox. • Open the gate manually approximately Imetre. . Close and lock the override lever on the gearbox. (PCB should beep 1-5 beeps pending on load pot setting) • Pull the gate in any direction until the gear locks in. • With all dipswitches OFF (excluding dipswitch 2 depending on motor direction), press & release the TEST/SET button. • Gate will close, open and close again and stop on close limit. (Motor speed can be increased during programming cycle by pushing and holding down the TEST/SET button, but release the button approximately 500mm before the close and open position). The final closing cycle of programming will automatically run at normal speed. • Control card will beep twice to confirm end of program run time (calibrating) setup. NOTE: 1) If gate opens first, dipswitch number 2 is wrongly selected. 2) Gate will automatically calibrate every time the power is restored after a total power failure, irrespective of present dipswitch selection. 3) The controller will drive the gate approximately 6mm past the closed limit activation position. Allowance must be made for this when setting the limit actuators.
?????????????????????????????????????????????
Useless video, wasted 13 seconds of my life!!! kont!