Відео

Would this stop the engine cranking over ?

It was the exact same spot for me except all 3 joints were broken and they are the 3 legs of hall sensor B for reverse and park. The other joints around the tcm are stable because they have a wider angle.

Thank you for this video:) saved my day:) I have fault code p0335 and it was a wire broken exactly on the same place :) Someday the car worked and someday its not, now it work everyday:) Thank you from Sweden :)

Is this the 2.0 ltr cdti or the older 1.9 ? Just paid £450 for a new injector jn cylinder 1 ( P0201error ) ,stop engine light above 3 k revs,,engine has vibration and delayed starting,,read crankshaft sensor can cause this ? Many thanks

Bravo

Nice dance!

Well done fella.grate little clip too.

When did this get 204 likes?

Retarc can't count nothing smart about this shit

Skipped 3

3 3 3 3

OMG ! Do people still actually fall for this? This is how a short change artist works and gets away with it. I hope she never works as a clerk at a bank.

Bozo dumb 😂😂

Him:you have will eleven fingers Three:🤬what about me

it a fun trick to do to your child

3 just became a John Cena transformer

Skipped 3 yeetly deet

Whaa

What

Bozo don't know how to count🤣

🤔

casually skipped 3.

You skipped 3-

Thank you so much for this video! 👌I had similar issues with a DF120 error (crankshaft sensor) on my 2.0 dci Renault Trafic 2007 (90 cv). It remains unsolved and drives me crazy for 5 months until I ended up here! 🙏🤗 I found 4 wires completly cut in the same location under the intercooler pipe. Thanks again from France! 👋

I have a similar issue, thanks for going out of your way to make the video it has helped.

wires on me crankshaft sensor plug was green what a ball ache 3 days been on mine . had to strip the wires back and get second plug from scrap yard .

my A6 C6 CVT DOSE NOT COMMUNICATE WITH this i have no dash lights as NOWT ON CLOCK DISPLAY NO PRNDS ON CLOCKS

hello is this need to coding thi unit after used gearbox remplacement ?

Hi what type of soldering wire and gun did you use to solder back the loose wires? I have tried using flux and normal soldering wire but wires are not adhering to the PCB

Hi. You will need to scan car with Vagcom

Hi all. Just inspected my TCM and all connections looks good but I'm getting the flashing gears in the cluster. What could be the problem? Thanks

How did you solder it?

Hello mate, can you tell me how did you put the black plastic back on ECU? What u used to stick it back?

Where is the tcm located at

Would like share with me info about the repair of this kind module tcm?

How do you remove the black top to get to the board insides?

Did this work for you?

Where is he located ?? PLEASE

Did it work? What did you use to seal it?