Відео

😊 u 😊

😅

0769208178 whatsapp

Thanks අයියෙ

yakada bateta pvc batayak athulen yawala thadu pati dekak gahala kelinnma kambi dekak gawenaa tiyala thiyenne light wadakaranne arduino

@@slelectronic6855 tnx

adi 7

udatama gi bate thiyenne

parana yakada kadawal wala

MOTER EKA HI WENA EKATA ANAYAK DADALA THADA KARA

car wala side glass eka ussana motare

Ok thanks bro

Ee moter hodaida

na resareta fit wena batayak gaththe

Oo

N chanel mosfet

You will need a 1.5 v relay but it's rare therefore we need to separate the 1.5v circuit and the relay blinking circuit.

@@thawzinkhant1759 thanks - how would you estimate size of resistor and capacitor to give similar rate of blinking to your 12v circuit

@@jonathanbrierley8304 on which one? The relay oscillator circuit? Or the application that is going to be controlled by the relay?

@@thawzinkhant1759 i was hoping to recreate your circuit with a 1.5volt power source and 1.5volt incandescent bulb and was wondering how to estimate size of capacitor and resistor in your circuit I would need to go with a 1.5v relay. Space for the circuitry to fit in is limited but I could potentially increase power source to 3 or 5volt if that makes relay selection easier and then dial it back somehow so the bulb only sees 1.5v.

​​​@@jonathanbrierley8304 To recreate the circuit with a 1.5-volt power source and a 1.5-volt incandescent bulb, we'll need to estimate the size of the resistor and capacitor for the blinking circuit. I would say 47 ohms resistor and 1000uf 16v capacitor would fit it perfectly if you are going to use a 5 v supply For the bulb You would need to use a 6.8 ohm resistor You may need to adjust the values accordingly.