![ALLEN](/img/default-banner.jpg)
- 154
- 165 550
ALLEN
Philippines
Приєднався 30 жов 2012
Personal Blog
One Road Trip at A Time🙂
One Road Trip at A Time🙂
Відео
Drone Quickshots #dji #djimini2se #camping #mountains #chill #carcamping #relaxing
Переглядів 365 місяців тому
Drone Quickshots #dji #djimini2se #camping #mountains #chill #carcamping #relaxing
American Pitbull Terrier Puppy Hang Time
Переглядів 3904 роки тому
American Pitbull Terrier Puppy Hang Time
Very nice combo
very nice tutorial awsome step by step tutorial very good think your sharing idea i salute you idol from philipines leyte province
Thank you, next road trip namin pupunta kami dyan dala yun Civic ko🙂
anu po senyales ng palitin na fuel pump?
Matagal minsan magstart idol, ramdam din lean ang takbo
You have to recalibrate the tps now...
that is unrea !))
Scroll shorts and see this. Beautiful
One of my favorite songs from KoRn
😮
best song
💽
That's just one of my favorite songs by Deftones. 🤟🤟
boss pang civic lxi matic ba yan ginawa mo
Yes idol, afaik same lang sila ng vti
Hii mag Kano yan
Wala pa ako stock ng pambenta ngayon boss, usually 3,5k sya
Good day sir, may pinepress ba para matanggal ung mismong board? Same issue kc sa akin yan, ttry ko sana gawin kso nag aalangan ako dun sa pagtanggal nung mismong board.
Thanks a Lot my friend.
My car is all fine with any other code but ABS Pump Motor which Iw ould carter later. I want to calibrate settings for performance of Fuel. Its Civic 2004 VT Manual D16W9 My electrician said with diagnostic that TP sensor and IMA Sensor settings are bit out. ANd my Radiator fan was on manual. I have did my fan on auto after installing thermostat. Now what calibration would I need? Readings at 750 RPM Fuel Injectors 2.90 IAC Commad 20.78% IAT Sensor 1.55V Readings at 3000 RPM Fuel Injectors 2.78 IAC Commad 20.78% IAT Sensor 1.63V 53 Degree C IMA 2.64 Does these looks fine? Can you please help?
this is how i used to do it but then found were supposed to start adjustment with throttle wide open first and set it at 4.5,then when its closed it should be at 0.45v.if the volage is off when closed you then adjust the throttle screw till it reads 0.45. you start at wot because if you start at closed throttle and say it reads 0.45 but at wot it only reads 3.2v or somthing other then 4.5v you cant calibrate it right untill you start at wot and then adjust throttle opening when closed till it reads 0.45 make sense?
I forgot to say that i adjusted it first on wot, my bad...
.50 and 4.51 it's ok??
Yes bossing
Thank u for this video 2022 salute to all from Los Angeles CA
Jesus Christ the music makes this unwatchable
Hi sir bat po ung sakin is 0.49v po ang TPS po pero pag inopen trottle po e wala pong reading. O.49 lang po. Hindi po nagbabago ung 0.49 po. Ano po kaya pwedeng gawin? Patulong naman po
Double check mo bossing yun connection ng probe sa socket ng tps baka di gaano nakacontact. Sa gitna sya nilalagyan ng probe.
@@AelAeo paano po ang gagawin po sir. Saan po ung probe po?
@@eillenjohnrobertacebedo2093 sa gitna boss ng socket
What tool do you need to adjust the throttle stop screw?
You will need a tiny socket wrench and a tiny allen wrench🙂
Naalala ko si Basha
Sinong Basha
@@AelAeo si Jap ito Boss Allen haha
Lods anu brand ng fuel pump mu? At mgkano nyu po nbli tnx Lods🔥🔥
Newstar yan ipinalit ko bossing, 900 po yata ang bili ko dati.
What a beautiful baby. 💜 Let him out to play
I did not see the outer boot seal and retainer clip. Eing installed.
I can't install it while filming 😅
Good method without cutting or stabbing the wire thanks for this info
Mine is set to 0.55 and when open it’s 4.57 is that a problem? Can’t get it to 0.50 to 4.50
It's a little high on closed you could be throwing some fuel already without stepping on the gas
I have a 98 civic with a b20b... I adjusted the tps to 0.50 closed valve.. and when I open the throttle fully it goes to 4.63 and fluctuate higher I can't get it to that magic 4.50 number... how can I fix that 2nd number
Try to adjust on the throttle stop screw
Щуп 0,03,,,между корпусом и заслонки,,,заслонка должна быть чистая,,,,
My thortle only get 3.8 what should i do? Thanks
Loosen the throttle stop screw then adjust🙂
@@AelAeo my engine is 4AFE, toyota corolla.. when thortle close get 0.43 when fully open only get 3.8.. is that normal?
@@iswahyudi5673 on a toyota, usually the voltage on closed throttle or idle is 0.6-0.9 and on WOT its 3.5 - 4.7volts
@@AelAeo 0.6?? Realy? i set 0.5 and 3.9.. my car is like jigling but now feels bettr thn bfore. But still jigling whn dclrtion under 1000rpm..
needed this video. Calibrated using only a single wire and doing car work in bare feet, how a real man gets it done!
boss magkano puppy sayo?
Wala pa available ngayon boss
Still jammin to this song bro bro !
Sir can u plz tell me how many volts tp sensor have Suzuki Liana 1.3 my tp sensor shows 0.7 volt at idle and 4.8 volt at full idle
I am not very familiar with suzuki engines at this time but afaik, the voltage should be 4.5 - 5volts on full throttle so youre on the safe side 🙂
I just tested my tps, it reads 0.50 on closed but pag wide open it reads 4.57 ok.lang po ba un or dapat tlaga 4.50? Tnx
Ok lang yun boss nasa range pa din sya ng 4.5🙂
@@AelAeo salamat boss naisip ko kasi baka 4.6 n un if rounded off. Naiwan kasi sa 1,500 ang rpm pag binitawan ko ang accelerator pedal habang umaandar. San kaya ang problem pag ganun?
@@drewcandle9449 subukan mo boss pag magadjust ka unahin mo ang wot, pag sobra sa specs bawas ka sa throttle stop screw
@@drewcandle9449 .45 mo set sir para bumaba ang idle
Gandang rednose nito ah
boss naglinis din ako throttle body civic 96, taas ng idle pagkatapos , pag uminit n 1500 idle niya, posible kaya n iacv kasi medyo buka na
Baka may vacuum leak boss
My non vtec d15b engine tps is reading 0.50 closed , and the fully open is reading 4.25 Can you help?
I think you should adjust the throttle stop screw on the throttle body
Or you could also grind the shaft that hits the throttle body just a little
Not water not food for him for them... Never wee see food. Or water... They drink when you you want???
No liberty, he s sleppi'g and you come to see him when you want in order to film him to UA-cam???
He s so tired, affraid. Of you!!!
Poor dog!!!!!!
Just doing little dog in order to keep money.. It s a job, it s a work.... Horrible person... I can see that yur dog are not happy
A little cage?????? If you knew what I swear for yu...... À poor dog in a little cage, poor dog... Why taking dog so?? It s a life????? If yu hav no time to protect them to play whith them.. Don T take animals!!!!
Poor animals!!! It s like that that they joke?? That s is a life for them?????? I can see that yur are fat... I understand much now... Horrible 'person.. And, I can see that your kick your dog!!!! Yu have not heart.. No mind... Your are a poor person... Stay alone with yur sad life..
The cage is too small.. Poor dog!!!
Alguien sabe q significa en pitbull 2 litters 1 litters
Cuanto por un cachorro
was that one of the puppies
Yes🙂
ohhh buddy