Відео

Didn't really answer

Emissions test ? HOW DARE YOU ! Lmao

Simple and clear explanation, thanks.

Sir i have a 2 wire push startwr button..anf have a lucas starter ive noclue where and howw to connect push button, Do you whatsap i can provide pictutes maybe ?

Sir i have a 2 wire push startwr button..anf have a lucas starter ive noclue where and howw to connect push button, Do you whatsap i can provide pictutes maybe ?

Thank you one of the best vedio about it

3 all of mine have in all 4 terminals the 2 flat ones for black and white or blue or purple whatever wire color your mower uses to it

My stuff uses the solenoids with 2 terminals i do have 1 terminal solenoids but didn't wanna waste my time hooking that up when the 2 terminal is already hooked up

Good

Bro this shit being made entirely with AI is crazy to me…

I have a ticking in my engine, it's 2014 Town and Country Van. I think it the lifter. I scanned the engine and it said cadlic converter need to be replace, and then it said sensor 1 PO 420, bank 1, and sensor bank 2 PO 430 needed to be replaced. When I start it up, I get the lights on the dash to light up like a christmas tree. Speacily when it's cold out and rainy, Not sure what that could be. But it's starting to drive me into det, lol Do you have any idea's???

Should you replace them all, I think there are 4 on my van, It's a 2014 Town and Country van?

Thanks ❤

If the O2 sensor detects no oxygen, it will add more fuel? That seems contradictory to me. Wouldn't a low/no oxygen reading cause the ECU to reduce fuel in an effort to attain a stoichiometric mixture?

What if, you install the rear O2 Sensor in an open pipe exposed? anyone has done this ?

Fuckin useless ass AI created video so vague

Ah been wondering why my engine is missing. Looked everywhere for it too!

With bad 02 sensor, the ECU is not misinterpreting signals. The ECU is correctly interpreting bad signals that come from 02 sensor.

I would rather replace it rather than doing anything illegal

Good idea and explication. My name is Hector from Puerto Rico. What you thick is code P0430 is on and the car run perfect? My car have this problem and sone technic, local and outside, tell than is the catalic other said than is the computer. I hope in your experience. Thanks for your explication.

Thank you !

😊

I'm diagnosing a P0113 code on a G6 3.5 and looking for the pin with 5v. My choices are. Pin A MAF sensor signal Pin B Ignition voltage Pin C GROUND Pin D IAT sensor signal Pin E Low Reference Looking for the 5v at the wire connector end to rule out a bad PCM. If I connect a multimeter, black lead to ground and red lead to 5v pin if I get no volts is my PCM bad? Is this test done KOEO? Thanks for the video.

veryvery thank you

I’ve got electrical problems.. car starts but dashboard lights stay on….. wipers don’t work and windows don’t work could anyone help with this problem 👍

Hi Your video clip is very helpful for me and other thank for making this video ❤

❤ thankyou so much sir❤ 🌹🌹🌹🌹🌹🌹🌹🌹🌹🌹

Hello sir/madam my fuel matter is not working can you tell me..

Don't waste your time.....

No need to turn the ignition on when testing the ground wire at 3:24.

What about when only one vent will blow warm air after a while and the rest are blowing cold

I have Tucson 2005 v6 gls And check engine light is present . When check by obd computer, code p0156 Oxygen sensor 2 bank 2 is found. Note : carbon of catalytic converter had stolen. Please, advise me.

I have Tucson 2005 v6 gls And check engine light is present . When check by obd compute, cod p0156 Oxygen sensor 2 bank 2 is found. Note : carbon of catalytic converter stolen. Pleas, advice me

Thanks boss

Award for the most use of the words "Oxygen sensor"

Cleaning it with the Rag ? I didn’t do that part just spray the dirty oil off and reinstall it back on

Veryvery correct

I have a faulty AC and dont need it and dont want to repair it. It is constantly running, I can't switch it of. Can I dissble it by removing the AC fuse?

I’m sure if you just piggy back a 1000uF capacitor to the O2sensor it will smooth O2 out out voltage enough

@Tunde Kassim

The only bit about cleaning the sensor is 8 seconds long (2:00 to 2:08)!

Where can I buy this simulators? Tried to look online and never found them Thank you

Excellent free class!

What about solenoids ground?

I have a 2013 Honda crv 4 cylinder and I need to know where the camshaft position sensor is, can you help me?

1 year broken sensor still going strong 💪 don’t make them like they use to

Will that affect flow

Helpful video but very repetitive commentary. Is she a robot?

20years still going Nissan Xterra v6

be careful your engine might go missing lmao