Відео

Is this the same for the 3.3 v6 Santa fe

Thanks so much Bennie. I hope all your viewers get a chance today to recount their blessings, large or small, and express their gratitude for them. Happy Thanksgiving!

I should do this after the car has run for a while right?

I got my 2017 hyundai sonata's engine replaced at the Hyundai dealer where a purchased the car. When doing so, i had them do a drain and fill on the Transmission because it was over due with 107k miles. Am the second owner and i bought car with 18 k miles. After a few months of driving the car i started getting a shudder at around 40 to 60 mph. At first i thought the tires were unbalance and when i went to have them balanced they told em it wasnt worth it because i need an alignment and i needed new tires. After getting new tires, its still doing the shudder at around 40 to 60 mph. So now am convince that the dealer must of screwed the drain and fill up and now the car shudders on the drivers side where the transmission is. I was to do another drain and fill my self, but i dont have an even surface to jack the vehicle up. I made an appointment at the dealer so they could take a look at it. But am afraid that they are going to scam me for lots of $$$. Should i wait for the dealer to check the shudder or should i donthe transmission drain and fill my self. Am a DIYer and do some things my self. But i have never done a drain and fill my self. Your video is the most detailed video on youtube on how to dona drain and fill on a Hyundai Sonata. But my worries is that i dont have an even surface to jack the car up. I could probally put the fron of the car on jack stands and then jack it from the rear with an heavy duty jack and check it tonsee if incould level it as best as i could. What do you think i should do?

thought the torque spec for front did on a 2019 was 25Foot lbs , that’s atleast what the dealer manual says

I need to drain my oil first correct ?

I had a 2007 LS460L with all options. Very expensive to maintain but I put on 200k miles on it. Loved the car and sorry to have sold it. Most highway miles. He’s correct, the air shocks are VERY expensive.

Thanks for posting this. Does it work with the 360 degree / birds eye camera system that comes with the platinum trim?

Pull submire

Pull submire

Excellent video. Bought fluid through your link. Great video. Question: did you meantion a tranmission programming update as a possible additional remedy ?

Just started inserting mine yesterday, I’m screwing in 2 clips per light to make sure it stays put when the tape gives out, even tho I’m using a hairdryer to heat up the sticky side.

Is that wire a 14gauge or a 12 gauge wire?

This was very helpful thank you.

Link for the adapter?

Do you need the engine running while draining the excess. Thanks

i’m about to mine 2019 ram with 3.92 axle and limited slip, I know everyone is saying 18foot lbs for fill and 44 foot lbs for drain and that does sound correct but I asked the dealer when buying my oil and they said the torque for my truck is 52 foot lbs for fill and drain and that sounds wrong to me :( they said it’s cause i got the 3.92 with limited slip ….

Bennie - Great video. I've seen a lot of videos RE the Predator 3500 Gen. In the owners manual it states that the generator must be grounded prior to use. But I've never seen anyone actually do that in any of the videos. Got any thoughts on this? Is it really needed?

This is doable with 6 jack stands and a warm garage yes?

Thanks for this awesome video. I followed your advice step by step and I was able to do this job by myself! Thanks.

i wonder if this would work on my 2010 F-150. maybe i could buy this and modify it with angle grinder if the frames are same width.

So I've had this issue for almost 3 years and didn't know how to resolve it, I had to disconnect the cable that indicates the trunk is open so it won't kill the car battery, and I casually strolled into UA-cam and found your video, just tried it and boom it worked, Thank you so much man I sincerely appreciate 😊😊

What if I want to change the gear oil filter for it?

Finally someone with something helpful. Great video. Even if my 2011 2.0tdi 140hp don't show fault code, it bangs, loose power, and as soon as it's slightly warming up it's gone. Have also changed the dcf but did not fix it. Well it fixed the rattling from the dcf so still happy I did that job(the garage did, 1700$). Well I think it's time for an obd checkup while doing it. In Norway it's NOT 450$ for 4 new injectors. Great help man👍

I really like the idea of using ODB reader to measure the temperature, as I do not have an thermal gun for this purpose. Is there any difference between 2011 Sienna and 2017-2021? Mine is 2011 and I don't seem to see any difference in the procedure.

Do you know if this would be the same procedure for the 2024 pilot with the 10 spd? Thank you in advance. Good video

Thanks for this in-depth look at the 2007. Mine needed very little to pass safety, a testament to their attention to build quality. The car runs amazingly...waiting for my next big road trip!

Cheaper than a transmission for sure

Had same issue. Encountered mine at 70k. Fluid drain and fill did the trick. More religious about changing after that

Hi...hows the sticky tape holding up?please share your long term feedback

Your a BETA male

How does this guy know so much about transmission fluid but missed removing 2 bolts so he could access the fill cap

Was going to originally get this done at the dealership, but after watching this video and Car Care Nut's video.. I think I'll save myself money and do it myself. Thank you!

I've got an 05' F-150 xlt supercrew cab 5.4L 3v, 79k miles....i thought i had enough problems trying to fix timing...I've got a slap, only thing reading on diagnostic is VVT solenoids...so i bought Motorcraft...truck has been sitting for 2 years in a part of my driveway that collects a few inches of water when it rains...my 16yr old daughter wants the truck...im scared to look after i seen your video...lol New Sub! Looks you went above and beyond for the customer...and did a great job...a would gamble and say you have decades under a hood...I grew up in a big garage with any tool i needed because my father and grandfather were both diesel mechanics by trade....my father had 2 very bad strokes, and has dementia now and lives in a rest home....we had planned in moving to Myrtle Beach SC, from Kentucky when he retired with the whole family...they were about to close on a beautiful property with 3 garages, where we were to build that hotrod we had talked about since i was a kid, spending late nights at the garage getting cars finished....he had 55 and 57 he sold when i was very young...i had a 79 monte carlo we played around with when i was a teenager....but we hadn't picked a chasis....but sadly he had a stroke 2 months before retirement and one a year to the day a second stroke that debilitated him...the 05 truck I'm fixing was his, when they took his license, he gave me the truck....and i wouldn't sell it for all the tea in China, i sure miss not having a garage just to pull in, with air lines a roll around for metric, and a roll aroundfor standard, didn't have a lift though, they worked on alot of busses, and big floor jacks, and big ol jack stands, i couldn't tell you how many pizzas i ate with my father working late at the garage in the 80's, id love to wash my hands again with that old GoJo hand cleaner, and get cleaned up and eat pizza with my father again,.. But, im real scared to look under it now...😬✌️

Like .Thank you. Hello from Ukraine.

Great report !!! Thanks for info. Very pertinent information. 👍🏿

Crazy you did it with 1 gallon. My 2.4 gdi 2012 optima manual says 7.5 us qt. Which I got similar extract I did measure it. That’s just shy of 2 gallons. Also to people scared of using the valvoline. My owners manual says ATF sp-IV Kia genuine or other brands meeting above specifications. Good thing I had bought 2 gallons just incase. Though I should have checked the manual first.

I accidentally removed a 14mm little bolt from right behind/under the plastic overflow cap. A few drops came out of it but it appeared to not really do much. Did locate the actual drain plug with magnet after wards…… hopefully my transmission isn’t broken now ha lol! Does anyone know what the little bolt near directly under behind the overflow cap does? Man, I always do something stupid doing repairs and maintenance on the cars!

Great video. Straight to the point. Looks like my next project on my truck

How much oil is required for toyota avalon 2015

When screwing into the soffit to fasten the wire clips, are you only going into hollow vinyl or is there wood behind the vinyl you’re hitting?

I have had to make my own weldable plates but I sprayed all the rust with this product that turns rust back to metal first. Then I did all the welding and after that sprayed everything inside and out with undercoating. This was 5 yrs ago and I sold the truck last year and the guy that bought it is using it to haul hay rolls to peoples cattle ranchs and he knew about the frame but still says he has had no issues out of it at all. He has also stated that no rust has come back at all. I think the rust converter was a very good idea and would recommend that that part of the process to be added to any rust repair. This is the product that I used for this Rust-Oleum Rust Reformer Spray Black. I got it from amazon which was the cheapest place to get it. I liked it so much I have started using it on every car or truck I buy just to prevent rust from starting. Its that good and no I do nit have an Amazon store lol

Do all these pilots have the same issue.? I feel like every channel talks about transmission problems. I was looking to buy one but every time I watch a video someone is always working on the tranny. Is this car even worth buying??

The question is. Should we be in neutral or park when setting the level after reaching correct temp? Should we be at neutral or park after cycling park drive neutral?

When I did my Toyota. There is a obd2 jumper method to check trans temp without scanner. Some people say just check pan temp with temperature laser gun, others say no because outside pan temp is not accurate to inside. I did both methods at the same time to check accuracy. My temperature gun was about 5 degrees lower when the obd2 jumper method to dash lights kicked on. In most cases I think temp gun to transmission pan is accurate enough. The temp gun is say is 5-10 degrees reading under the temp inside the trans pan

i have a 2010 nissan altima 3.5sr the transmission slips a lot it runs and drives fine it’s just making a loud noise, could the fluid possibly be empty or do i need a transmission replacement

I have a 2006 honda pilot and I've noticed a couple differences. 1 - the owners manual doesn't say anything about waiting 60 seconds and not longer than 90 seconds or whatever and 2 - my transmission dipstick seems a little different. The 2 dot hole marks seem to be more towards the end of dipstick compared to yours.

I have a 2015 Santa Fe limited 6 cylinder watched your video.Very easy , how long did it take to do this transmission fluid job.

Does this not have a transfer case?

I've been having this problem for the past 2months with most mechanic unable to sort it out. I will now return to instruct them on changing this . I did some personal checks and found oil all over my oil sump. Thank you Thank you Thank you. This video is very helpful