Відео

Grab on Amazon here Amazon amzn.to/4fIRH6E Reuploaded the video to fix the trash quality :)

There's a lot more to sharpening a chainsaw than that. How about the rest of the lesson?

Get the file on Amazon amzn.to/3LGamSP

Get the cardholder on Amazon here: amzn.to/4fc9H9d

Materials: 2 2x4x18”, 2 2x4x24”, 2 1x2x60”, cardboard (Amazon boxes are great), staples or clamps. Have fun 🎉

Which screw driver ended up working ? PAC man ?

What’s the noise level like on this unit?

Awesome job, Thank You 😊

You're making a mistake by installing this low surge capacity, high frequency, transformerless inverter in your camper because it is not UL-458 safety certified for use in mobile applications.

I have a International B275, is there much difference between B275 and a B414 cosmetically?

I just tape on the screwdriver.Super video.

Is the final drive oil refilled by the trans as well?

That orange romex is 10 gauge. And the Renogy I/C specifies 4/0 DC wiring with a 300 amp fuse...

The hydraulic oil in my. 414 came out like mud I will need to changeagain

Like the hat at the end.

When you order your spring and gasket for the oil filter order your shifter boots that is where your water got in at it must of set out side most of it life.

Your little river here looks a lot like the one near me that I enjoy in my Pelican Intrepid. Happy Fishing!

From what I could find, the 3,000 watt needs 4/0 cable? Some charts said 3/0 so just went with the heavier cables. The 110 volt wire needs to be 10 gauge to get full use of it. My plan is to use 2 x 230 amp hour LifePO4 batteries, 4/0 cable, on off switch, fuses, etc. my plan is to put a 30 amp female plug inside the compartment beside the inverter where I can just plug shore power cord into it. The camper will think it is plugged in? Should be plenty of power for off grid/no electricity campsites? About 5.5 hours run time for microwave, about 1/2 that for the AC. As soon as it cools down, the only draw would be the refrigerator, 12 volt fan, lights, TV, 12 volt pump, etc. I currently have 190mwatts solar, going to add 200msoon, then another 200. That may be all I do, or add batteries as I get the funds? I went with REDODO, great reviews, incredible value, if they work/hold up, lol

Great looking B414, it is a late model B414 just before 434 was released. My Dad had had a very early 1962 B414, a very good tractor.

thats a little toy not a chainsaw lol need a 450 rancher

Boy, it always looks soooo peaceful there. Too bad cars didn't have thermostats that easy to get to. Not that you change them oftenl anymore, but back in the 70's, 80's, it seemed to almost be an annual maintenance item... they didn't last nearly as long.

❤️ *Promo SM*

Hi. I new to this campervan lifestyle. I have the Renogy 2000w Pure sine inverter charger but the company that installed it in my van put it in the back of a cupboard that i have No access too.. so i cant access the screen to see battery power. So i need to a add a battery monitor screen. I was thinking of purchasing the Renogy shunt monitor to connect to my Renogy 200w pure sine Inverter charger. (I contacted Renogy directly but they've replied saying it cant be used with my 2000w charger inverter) (I am a bit confused because I've seen videos on youtube of people using them together). Can i use any Shunt monitor to my Renogy charger inverter? Thanks

Ok want more 2023

These are used for both shore power and inverter.. As they have a built in transfer switch at 10ms....That is why they cost more...As you can plug shore power in as primary. Then when you disconnect it. It will switch to Battery power till you plug it back into shore power.. And you can pick either Shore Power as Primary or Battery as Primary...

Lucky with that pin on the tractor, would of been a right pain to get that back in

Good day Yea I remember oiling the gen with that little rubber button. Seem kinda nice in boat strolling along. Thanks

On cjinese shainsawe notvsade end recomended..,,easy way is to take a good scainsawe end giwe to heer a little botle of HHO gas to clean head end rings,, to stay in good Shape all year..that is a simply end good caring yob to the chainsawe....only in gas you must to put 5% procent of mixture with oil,,,,try liesen the sonda of mashine end loock on wood than say wat you see...

3000W/12V = 250A, 4/0 would be the minimum to be used as per NEC

Water

Good day from Waterloo . So were did u get starter from ? What did it cost? U know alot of shafts should be oil. Just a few acres rook his gears shifts oil. Thanks for now.

I had never heard of an oil bath air cleaner...cool. Always nice to get all of the lubricants up to spec.. Boy, that trans fluid was disgusting.

cheers Eric, love that little tractor

I changed the thermostat in mine and it still didn't come up in temp on the gage. Seems like the gages are wrong or the bd154 is just not a hot running engine. I can pull it hard on a hot day and it still doesn't come up much.

Hydro full to the top? If you fill that full to the top, half will leak out.

No power steering with a loader on a B414...that's painful.

Oil will always be black as coal coming out of that tractor...no worries.

They recommend 3/0 for the 3000w, I have the 2000

How can you use Romex wire in a camper? I don't know why the code still allows it... Only stranded wires with terminal connectors should be allowed. I see it everywhere in the North American campers and I freak out.

Good day R u from Goderich? Thanks tractor sounds good. Thanks How is weather up there? I am from down by Waterloo Ont.

DID NOT SHOW ANY WIRE CONNECTING OR WIRING

Niiiiiiiiiice!!! You should research P r o m o S M.

Interesting, thank you! Looks like a great place to be.

It looks to be warmer at the camp ...lol

Hey man you're rv is 30 amp and this inverter works good In your rv

Good day from Kitchener Waterloo area. Back in 67 we bought 414 from dealership near University of Guelph with 25 hrs. Good tractor but hard starter in winter with 30H battery 570 amps ? Now I 31a has 900 amps would be alot better. I guess I will have to sub & ring bell. Thanks for now

Next episode, the tractor gets led underglow lighting. Lol

Great work, tractor is looking awesome

Coming along nicely mate, lovely little tractor

where did you get the panels?