Відео

Brother this was exactly what i needed to see! You saved me from spending a ton of money. I hope you make more videos! Thank you

I can hear a shit bro.. talking like robot cop or wat?

Amazing content

My 2011 Camry xle passenger vents are making heat while in a/c mode ?

I just installed one in a 2015 Toyota highlander which is the same assembly. You will need an assistant to help you install this. it makes it easier if you remove the passenger seat and can lay on your back. You will need to grind some material off the back of the assembly without grinding the actuator and grind the dial guide cylinder (don't remove to much only 1/8" in needed). This make it easier to maneuver . Make sure the parts do not have burrs around guide cylinders. You may need to grind material around the blower motor housing to get the part into position. You will need to install the electrical cables on the assembly. Get the top two guide cylinders that aligned the arm and dial into place. The part will be tilted out slightly at the bottom. Have your assistant crank the vehicle. YOU WILL NEED TO BE VERY CARFUL while doing this as you can break parts. have you assistant change the setting such as the circulation mode from inside circulation to outside circulation and from feet to defrost. The dial will turn and like a combination lock you will need to keep slight pressure (but not too much) on the assembly. Allow the part to be able to push off if needed whole turning. This will take some time, and finesse but it does work (about 30 min). The bottom gear and pin is the last thing you will need to align. To do this adjust the temperature setting (ensure that sync is off). Change from hot to cold or cold to hot until you can see and align the cam gear. Once you think the part is aligned correctly hold the part in place and have your assistant go through all the setting to ensure the part is working as it should.

Not so simple. You do not dismantle this part on the Venza. It's harder