Відео

Looking forward to seeing it run! Good luck!

I'm currently in the middle of restoring the TS125 ER. Previous owner bent the shifting forks somehow. These bikes are so simple, and amazing rides. Do you know what kind of power the TS250 generates ?

We have one here in the states sitting around. would love to see this direction running. great project!

My first bike was a ty 50 cc. 👌😅 Nice clip 👌👌

One of the worst handling trail bikes of it's time but it had good power. Nice to see one again.

Gorgeous!

Where did u get the big bore kit?

That's a stunner. If I were you, I'd be utterly unable to let it go! (Tragically, I'm in no position to take it off your hands [seems like a remarkably low asking price].)

For Sale £3995 collect Grantham

Kick start has quite an increase in ratio to turn the engine so removing the generator cover and using a breaker bar directly on the crank end bolt will apply much more effort to the seized parts. The worst siezed pistons i have seen were totally fused to the bores and required the conrods cutting to get the motor apart. With the price of parts today a replacement engine is your best bet!

That tank is worth more than the whole moto. Looks like old school coffee bar special. It's horrible! I love it!! Would not change a thing!(Maybe a front fork brace). Ultimate Rat Cafe!!🍺🤠🍺

Rust remover contains acid, not good.

Take the plugs out and tow it slowly

Rusted distribution chain?

I think it is needing a refresh, the bike needs some work but will be awesome when up and running!! Take it apart freshen things up ( clean and check ) reassemble; enjoy!!

A mechanic friend once demonstrated the amazing abilities of Coke Cola, to unseized stuck pistons, on a FORD Granada engine. He filled each cylinder, after removing the head, with Coke Cola, on a Friday and by Monday, the engine could be easily turned over by holding the flywheel with his hands. Previously, with two of us pulling on an attached steel bar, the engine had been stuck solid. Phosphoric Acid, found in Coke Cola & Doctor Pepper, dissolves rust, oil gunge and other engine crud, very effectively.

Drain the crankcase, then go get some AE Half and Half, a 50/50 of milk and cream. I know it sounds strange, but I've used it on several stuck engines, and it has always got them broken free. Try it and see. What do you have to lose ?

Even if you can get it turning you will be stripping the engine and replacing big parts, the easier rout would be to try and find another engine.

As soon as I saw these on the thumbnail I recognised them from this week's Junk & Disorderly!

I would at least pull the top cover to see what kinda shape the value train is in and scope the cylinders. If the top end is all rusted up you're probably wasting time. JS

Sorry this is sold and on the road now. See website for stock Motorcycle Reclamation

What's asking price ?.

I hope you get it running mate. Get to the pub and have some beers and things won’t seem as bad👍

If you are 100% certain the bike turned over when you purchased it, I think that flooding the bores is not going to help. It may be that a piston ring has broken or the crank has seized once debris has been lifted from the sump and into the journals. I would get a borascope in the spark plug hole first and then try to get the head off to determine whether it is a piston issue or a crank issue. Fingers crossed for piston ring issue because a crank issue will probably make the repair not financially viable. Hope this helps! Oh. before you do that have you tried to see if the engine turns backwards? There could be debris on top of the piston, not allowing the engine to do a full rotation.

Looks cool, Old school!

Seized crank. unless you specifically want something to do over the winter, bin it and get a 400SD motor from a breakers.

1, Acetone + hydraulic fluid 50/50 mix. Leave 24h. 2, case cover off, big spanner on crank backwards and forwards , a LOT of heat on barrels, plumbers gas bottles too weak, go oxy, you have to get the steel liners quite hot inside. ( from experience)

If that's the case I doubt you're looking at simple ring to bore stickiness. Acetone and ATF 50:50 has always been the best easing oil I've found but that's on stuck stationary engines with iron barrels that don't have the degree of rubber/synthetic seals that acetone can beat up. I'm thinking it's had water ingress through an open valve and you've got a seized crank. They're not difficult to strip and it'll probably be quicker than pouring gawd knows what down the plug 'oles and crossing your fingers. At least you'll know.

stick it in high gear and rock the bike backwards and forwards

Hi Ithink the problem with the frantic is all that glass, but especially the Mag type open wheels, they are not allowed at MX tracks for safety reasons look in the ACU hand book. Sorry you had a wasted trip but that is for everyone’s safety

Love the Megaton alloy end cap Zorsts !

As an ex-Mocheck Honda mechanic, doing the engine is the easy bit because they’re very straightforward to work on. Time consuming on the cycleparts etc are seized nuts and bolts. There shouldn’t be any rust in the tank as it’s aluminium. You’re looking at a complete gasket set, also for the carbs plus battery, liquids, tyres, brakes and maybe even clutch. Once up and running it’ll make commuting fun.

Lovely rolling chassis and set up well...but choice of engine is questionable..they weren't the "Fastest twin on the planet".....nice find all the same.

They don't allow older bikes!!?? Disgusting.

It deserves a second chance, go for it. 🔧👍

It’s a h*nda - just put it back and nobody will know you had one

Do it back up as is and put it back on the road! Looks like great fun!

Tell them to stick it. plenty of other tracks and clubs who'll take you... PS.. a rare Fantic🏁🏁

Greetings from the jersey shore.Our local MX track has become more for advanced riders.Way dangerous for beginners but they still allow not with those bikes you have.

The CB400 super dream engine is one of the best bike engines ever made for reliability, id love to see that turned into some sort of street scrambler, styled on a '60s British bike, the Snetterton seat and tank have to go elsewhere, but that engine will run forever with regular oil changes, I had a 250cc super-dream and that was a lovely bike for plodding around on, very friendly and forgiven engines. some t**t stole it and wrecked it, when I found it it had blood on it from the thief, happy days,

Looks like a lot of mis management going on considering in the past you've ridden there ok.

That needs saving and put back on the road.

I would be tempted to do it up, tank looks like it was made to fit an oil in frame Triumph

Absolutly GORGEOUS !!!🥰🤩🤗

super nice bike!

Dude!

i had one in 1980 in coventry x mcn test bike

Nice bikes them. Common fault is the gear selector but it’s a cheap easy fix.

I just wonder if you are going to sell it a bit too cheap....🤔 I really don't know how many CBX's are still running on UK and what are the prices in there. But in Finland these are very rare bikes and what I know Honda import did make me a offer to buy my CBX at price of 4000€!!😬

❤ I love it!❤