- 1
- 63 139
Brad Sherman
United States
Приєднався 15 лют 2010
Putting in the boat Lifts
Using sealed pvc pipe to float out the lifts and lower them slowly into place. One is 10" and other is 12". Both 14ft long.
Переглядів: 63 152
United States
Приєднався 15 лют 2010
Does this work with an older lift where the end section project out and not straight down as shown in the video? Also how to attach the toggles used to secure the canopy to the frame? They do not seem to fit without possibly drilling additional holes to secure. Thanks for any suggestions you may have. Ann and John
Great lowering method too. Nicely done!
Wow… that’s so shallow there I’m surprised they can get the boat on and off the lift
Correct. This lake is dam controlled and the lift stations were put in before the water was raised.
Where can I see a boat drive up on one of these ?
Work smart not hard, great idea!
What size pipe did you use ?
How did you seal the end of the PVC pipes? That doesn't look like caps and glue.
Where did you purchase your PVC tubing and end caps.
Darrell Dahl got it from a local farmer.
That would end in a question mark not a period.
Minimal equipment investment and good use of mechanical advantage with ratchet straps.
not doing that in Minnesota in late April. Better get some waders!!!
five guys-thats looks like fun-who lost a finger -we have air bags for that
Bob Tack. Air bags? You mean the $1500 airbags and 3 yr warranty?