![Loren Haus](/img/default-banner.jpg)
- 43
- 309 044
Loren Haus
Приєднався 27 вер 2010
Hacker Boats 8.1L Marine Power w/ ZF Hurth 68A Transmission
Hacker Boats 8.1L Marine Power w/ ZF Hurth 68A Transmission
Переглядів: 361
Відео
5.7L Volvo Penta GXi with Closed Cooling Restoration Test Run
Переглядів 10 тис.4 роки тому
5.7L Volvo Penta GXi with Closed Cooling Restoration Test Run
7.4L MerCruiser Horizon MPI With ZF Hurth 63IV Transmission Restoration
Переглядів 6185 років тому
7.4L MerCruiser Horizon MPI With ZF Hurth 63IV Transmission Restoration
6.2L Direct Injection Marine Engine Package
Переглядів 1,6 тис.6 років тому
6.2L Direct Injection Marine Engine Package
Twin 6.2L LS3 Marine Power Engines w/ ZF Hurth 63A Transmissions
Переглядів 1,7 тис.6 років тому
Twin engines ready to ship to a customer overseas and install into a custom built boat.
5.0L V8-270 Volvo Penta Engine Packages w/ ORCA Closed Cooling
Переглядів 4,3 тис.6 років тому
5.0L V8-270 Volvo Penta Engine Packages w/ ORCA Closed Cooling
(2) 8.1L Mercury MerCruiser DTS Engines Fully Restored for Stephen T.
Переглядів 9616 років тому
These engines were partially submerged and were extremely rusty when they arrived. The engines had so much water in them, the oil pans were full of water and the oil was sitting up in the valley of the engines, in the cylinders, and in the exhaust ports. The starters and alternators were seized, the pulleys were rusted and badly pitted, and the wire harness connectors were all green with corros...
8.1L Horizon w/Dart Block lower end noise
Переглядів 2707 років тому
8.1L Horizon w/Dart Block lower end noise
8.2L 502 Marine Power Air/Steam in Coolant Problem
Переглядів 1 тис.8 років тому
Video for marina mechanics to see our diagnosis of incorrect coolant caps. Low pressure caps cause lower boiling points, which in turn causes coolant to boil while passing through the cylinder heads. Installing higher pressure caps increases the boiling point of the coolant, thereby reducing the amount of steam being introduced into the cooling system. This keeps the coolant water from literall...
454 Chris Craft Engine Restoration - REVERSE Rotation
Переглядів 7 тис.9 років тому
Brief engine run video for customer preview
454 Chris Craft Engine Restoration - STANDARD Rotation
Переглядів 1,8 тис.9 років тому
Brief engine run video for customer preview
Deer in Parking Lot
Переглядів 759 років тому
Found some deer munching our bushes on the security cams today.
3.0L Custom Inboard Engine with 70C Transmission
Переглядів 64310 років тому
3.0L Custom Inboard Engine with 70C Transmission
2004 8.1L Indmar 420HP in MasterCraft X80 Rebuild
Переглядів 1,9 тис.10 років тому
2004 8.1L Indmar 420HP in MasterCraft X80 Rebuild
MerCruiser 350 MAG MPI Burning Oil
Переглядів 1,1 тис.10 років тому
MerCruiser 350 MAG MPI Burning Oil
3.0L Michigan Adventure Train Engine, Custom Build
Переглядів 45110 років тому
3.0L Michigan Adventure Train Engine, Custom Build
Waterford Township 6-27-2013 Flash Flood
Переглядів 1,9 тис.11 років тому
Waterford Township 6-27-2013 Flash Flood
1977 Silverton Flybridge with Lumitec SeaBlaze 3 Lights
Переглядів 5 тис.11 років тому
1977 Silverton Flybridge with Lumitec SeaBlaze 3 Lights
1977 Silverton Flybridge Sea Trial
Переглядів 3,2 тис.11 років тому
1977 Silverton Flybridge Sea Trial
1977 Silverton Flybridge Fully Restored Chrysler 318's
Переглядів 4,4 тис.11 років тому
1977 Silverton Flybridge Fully Restored Chrysler 318's
1977 Silverton 318 Chryslers Restored, Port Engine Run Test
Переглядів 8 тис.11 років тому
1977 Silverton 318 Chryslers Restored, Port Engine Run Test
6.2L LSA Engine Install & Lake Test
Переглядів 6 тис.11 років тому
6.2L LSA Engine Install & Lake Test
6.2L LSA Supercharged Engine w/ Bravo III XR Outdrive
Переглядів 16 тис.11 років тому
6.2L LSA Supercharged Engine w/ Bravo III XR Outdrive
1977 Silverton Flybridge Lake Test
Переглядів 4,7 тис.11 років тому
1977 Silverton Flybridge Lake Test
This looks like Lake St Stupid... :)
what's the part number for that heat exchanger
My silverton appears came with 360sdies anybody know what year this may be
Hi there, Im trying to convert my raw water to heat exchanger on simular 5.7... different heat exchanger, cant figure thermostat housing part. Do you have any videos where its visible ?
Beautifully quiet engines!!
Where is the thermostats located at
What our drive do you have?
He's running a bravo 1 drive
Damn!
I have an 88 Sea Ray 268 Sun Dancer with same motor. This boat actually gets up and moves well for a boat of it's size. Have to say it has a ton of torque!
Just bought a 34ft Sea Ray with these in it, what kind of oil and coolant do I buy
trim that think out!
Looks and sounds nice. Canyou tell me part numbers for this kit? I have the exact engine and would like to install this kit
Where can I get the closed loop cooling kit for a 2012 gxi 5.0?
www.iceairklima.com
Replaced plugs wires coil cap rotor throttle position sensor map sensor n fuel pump switches over to different fuel tank its 02 502 mercury horizon boat will teach up to 5000rpm @ the dock but as soon as I try to go over 2000rpm under load I have twin motors n the other motor is fine any help would be greatly appreciated ty
Hey I was wondering if u know anything about the 2002 mercury horizon 502 motors I'm having hogging issues under load
Sounds like she's got a loud knock at idle...... Just kidding, Sounds tight, ready to give many years of dependable service. If Maintained......
NOT A GOOD VIDEO BECAUSE YOU HAVE TO USE A INVERTER THAT USE 3% MORE TO CHANGE AC INTO DC POWER. WHY NOT ONLY USE DC POWER ONLY WHER IS THE ADVANTAGES
I live near that old hungry howies so i remeber this
What's your fuel consumption on this? I recently acquired one of these with twin Chrysler 273's and one engine wont spin faster than 2900rpm under load and our fuel consumption is somewhere around a gallon a mile give or take. This seems way too high for twin 273's. Also we get slight fuel out the exhuast on the port side (2900rpm) engine, any thoughts? Thanks.
I have this in my jet boat. Well worth the money
Hey! I'm in Harrison Township, so we're neighbors :-) did you guys machine that stock motor or drop a MAG in? You weren't worried about added stress to the transom or weight differences on the hull with the different engines?
Engine's weigh the same.. a 383 used a 350 block
Is the Zf 63a any good for speed?? Thinking of bolting one onto LS1 and putting it into a ski boat, what do you think??
Is it me or shes a no sound so good?
So quiet! And smooth!
I'm so glad I'm living through the fossil fuel era......cannot imagine everything all electric some day...sweet sound.
what engine...
It has a twin inboard but I think it’s got a 1.78 liter
38 foot Fountain Cigarette Boat? lol
I am currently removing a 454 just like this. Have a Manuel but really like how you did the electrical. Is there a diagram I could use, thanks.
This is my dream boat
How fast did the boat go at WOT? Nice sound tho👌
Great video! I have twin 454 cu in that I'm replacing with twin mercruiser 3.0 L engines for max range and efficient cruising. I wish you could go into more detail on how to did it. For example, my mercruiser is a 1984, but the flywheel is not 14" so the starter possibly wont fit? Mercruisers made after 1991 do have a 14" flywheel and will fit correct?.....anyway, you got 26,000 viewers interested in your project! Good work!
what oil do you use in these motors?
Great job! That's what I wanted to do with "Tia Maria II". Hopefully "Deck Of 51" turns out as planned. I've always thought that Chrysler 318 was the best marine engine ever made, for petrol anyway. Love that sound! Thanks for posting!
Didn't watch all the way through. it's crazy how pressure will increase the boiling temp.
blown head gasket. combustion. leaking into water jacket
+Kody Klink look at the end of the video. The cap was the incorrect pressure. Head gaskets are in perfect shape.
www.michiganmotorz.com
I have a pair of these engines in a 1978 25' Chris Craft Catalina Sportsman. I have had to switch to those Carter fuel pumps. Where can I find the relays you are using that are CG approved for marine usage. Do you have a wiring diagram available? Roger cc251978@yahoo.com
what size is the beam on the boat and are you happy with the 2 lights? or would you do it again with 3?
Love the video man badass .
Love the video man badass .
Love the video man badass
man keep up the great work love the videos
I machined it myself. they aren't available from mercury at the necessary angle.
+Loren Haus How much to purchase them from you for the 2bbl Mercarb?
If you still monitor these videos, where did you get your wedge block for the Mercarb?
I love teddy bears too little baby..aawwee
Hi, We are looking at doing this on a Mercrusier 4.5 to go in a old classic wooden boat, any ideas on the bell housing/gearbox/drive options, we are going to use a 4.5ltr with the bravo option so the seawater pump is already fitted but need to sort out the gearbox, any advise is much welcomed!
I have these engines in my 30 Sea Ray. Question, what should the temps run when running at 3000 rpm? One engine temps at 170 and the other at 220
Alan Rothfuss Check termostate.
I have an 31 Convertible 1977 Silverton and she is in need of some TLC. Would love to talk with you about what and how you did your makeover. intelbubby@gmail.com
Loren-I have a pair of these engines that need to be rebuilt. How can I get in touch with you.