Відео

Aesome😊

That round adjusting wheel is to adjust the single blade when cutting Cat6 wire. It has no effect when cutting/stripping RG wires.

Handy

If none of the lights light up but the power light is flashing then is there any other possibility than "all lines are cut"? It's the same situation as turning it on without a cable connected at all. This is a CAT8 cable so there is a ground, battery is new & known good cable runs the sequence fine.

Thank you. I’ve always used wire nuts but these are cleaner and simpler

but i saw some with full rj45 connector, better to put the whole UTP plug without playing with individual wires of the UTP

Good video as far as it went, but would have been useful to see a demonstration of preparing and fitting the F connector and also perhaps some advice on how to find the best signal including when to fit it flat and when to fit it at 90 degrees.

Nice

since you used a needle nosed pliers your jelly button was not flat, but at an angle. It is important to make sure the button goes down nice and flat to indicate a good splice on both wires :)

Glad this video is out there

Where rest of vid, especially when u was doing good

What does it mean when the flashing leds are really dim but working in the right sequence?

I was listening to Aerials covers then I got this!

💥💥💥

The ratchet lashing brackets are brilliant to install been doing so myself for years , but have to say that one he was installing is crap pay a little more money and get the ones with two ratchet s on it much better and more secure just saying!

You do not need corner pieces they are only used for metal lashings to stop the wire cutting into the brick that.s why it is so easy to fit. you will also notice he did not have to leave the cat ladder to install it

How do you fit the plastic corner pieces? You don't appear to have fitted them in this video will there be a follow up?