Відео

Excellent

Good find, Did he replace heater ?

Amazing patience you have - not sure I have the same amount! Can you buy the LED’s separately from the housing?

Nice...

You are great! Thank you

Thanks!!!! Your video saved me, my air conditioning is running again, my car came into service and the mechanic forgot the plug. Thank you again. With kind regards from Potsdam/Germany

i have the same problem but have LED. Because the plastic was cracked anyway i bought a complete new unit ! and guess what still the same problem REAR INDICATOR FAULT!

Hi! Why the MIL (check engine) light dont't light? It is normal? Or it light only, when it installed on car?

I locked my keys in the car in the ignition... Do you think there is a way to access the central locking module somehow with a dignostic connector plugged in somewhere like the ECU/ABS connector via K-line?

If I connect it like this, after putting back into car, do I need to reprogram anything with diagnostic, is there gonna be any fault codes ?

Can u tell me why my dashboard doesnt beep only at low fuel it beeps And also i dont have lcd screen or it doesnt work

Thak you

Which vcds you are using.I want also to buy.thanks

:) thanks

I did the same and when I unplug the first cable in the fuses box. The current drop to zero in the first cable, someone know is the problem is in that box?

Is the best video I have never seen about diagnosis

how can i remove component protection

Great video! I noticed on my car that when I put the amp clamp on the draw seems to be constantly cycling building up into the 300 mA. You mentioned on your video that the drain was constant and not changing, but what does that tell you if it is constantly building/resetting?

Please Sir I shall be very grateful to you if you can be kind enough to help me for my request, My name is ESHAN KORIM iam a . mecanic worker , LIVE at DAMREE ROAD , MAURITIUS , want to have supplier for spareparts of polo volswagen , their name and address, if you have it I don’t mind please send me your price list of the pareparts and mode of orders and payment , in the meantime sending you the HORSEPOWER OF ONE OF THEM that I needs. Hope you have understand my needs and will kindly considered it,Awaiting afavorable response urgengly From ESHAN,MAURITIUS

thanks:)

What's the name of the module that needs to be replaced?

Svaka cast majstore

After you replace that fuse,ligth is still on until you drive over 10 miles per hour , once you reach that , the ligth should go off.

i want to do the same on my car

Did it start I’m having same problems right now changed alternator starter and 2 new batteries I need help please any info please 😰😨😓

Hello and thank you for the video. I disassembled the instrument panel following a problem with the tachometer, the first ten seconds the needle of the tachometer remains at zero and there is a noise caused by the small motor which drives the needle, this one this must be replaced. I had seen another video with the same handset as the one that equips my Golf IV TDI 110 AHF engine, to power the handset on a table, it gave pin1 and pin 23+ and pin31-, the handset does not light up, in my case it will be just to calibrate the needles when I replace the small DC motor. Could you send me the electrical diagram of Elsawin? Pour information, l'ensemble du combiné d'instrumentation peut-être contrôlé avec VCDS ou Odis programme sans devoir démonter celui-ci. Thanks in advance.

How can i acquire the Car diagnostics software?

Thanks. Tested at passat b5.5 clusters and works okay!

Do you have the conections for IMMO 2 Audi A3 8l with green and blues 32 pin and red 20 pin?

Hi there, what does your power supply use in voltage and ampere?

Could you please send me your phone number please

Hi very well done Sir clever man. May I ask you about my issue, is I have bought a new light cluster due to Led's not working on near side rear and still don't work with the new cluster, so I've no power going to mine so what could be the issue in this case? Thank you.

How did you turn on the backlights? I can't do it.. *cry* What pin did you connect?

Excellent video, thanks for sharing.

hi from london , where do you get the wiring diagram for the ecu , bcm , dashboard and ignition switch ????

I just bought the Ancel PB100 which seems to be the same unit, I’ve seen about 4 that are identical at the same price range and they all have rather good reviews. It’s super useful to diagnose stuff on vehicles but it’s super dangerous for people who forget that you send power to the tip... I’ve heard quite a few people blew ecu’s and other components by powering the wrong wire

great job my friend,i will check mine as well and try your way.thank you

Thanks for putting video up. Proved to be my issue. Fixed.

Oh btw on some Toyota lights are negative activated.

I have the same unit and I love it. Cheers from Australia 🙂👍👍👍

Nice, great video.

Thanx, I feel more confident about doing my own service now.

Can you give me number of led where can i buy?please

i think this one is for vw polo classic not golf 4

how did you check the voltage drop on the fuses?

Skip to 3:22 😊

Thank you

I have been watching video's diagnosing parasitic drain on bmw's all day. No doubt this is the best! Thank you sir.

Nice video, subscribed.

what type of led are in stop? I have 1 possibly burned piece