Відео

seem to have a lot of issues around the bearings and the hex shafts had a roller break in half in Australia $2800 to replace the damaged parts

Good video, but you should always shut off the tractor engine while working on implements. 🤕

Why is this video only 1:59? I’m having issues with mine. I’m having issues with mine. I’ve tried several different aftermarket cylinders and ended up having to buy genuine new holland for it to actually work. It’s almost like the plunger on the aftermarket’s wouldn’t go in as far as the new holland. It was a pain in the arse figuring that one out. Aftermarket’s were $100. New Holland was $600. Smh.

Thanks for the video. May I share the gospel of Jesus Christ with you?

Have you run into a problem with the transition stuck in neutral

How do you remove that roller,do you push hex shaft out to raise roller?

How you know if its bad

佐々牧場で生まれたばかりの子豚達に会いたいです。！

佐々牧場で生まれたばかりの子豚達に会いたいです。！

You skipped the hardest part! Getting that dang rod out that holds them together.

Where is the slave bleeder?

Easiest way to put them new belt pins in is with a cordless drill. You can spin 'em in almost all the way and tap the last little bit with a hammer.

How long did this take you? I’m about to do the same thing on same tractor!

Had the same thing just happen to me,only my baler is a1470 gehl broke in same place also took out 2 chains and torn one of the main belts roller was $800 Was one big job putting it all back together, Still dont undstand how this happend.

How do you find the 7740 on the round baler? Looking to pick one up but just about the power on a round baler.

Its 10x easier going through the back. Way easier.

My son and I just did this with the baler open and a ladder in an hour for all 6 belts not using the pto

I used this method recently. It does work well and very quick. Be very cautious around the PTO shaft since you'll be next to it, while it's spinning. Also, might add to alternate outside to inside. If you just go from right to left, the belts get twisted and won't feed correctly. Be safe, and try it. Saves a lot of work...

Beautiful family. Bless you.

I have a jd580 and everytime i start a New bale i need to drive very slow because The baler gets stuffy and many Times gets stuffy even if i drive slow. But IT happen only at starting every bale. The belts are The reason?????

No it's not gonna be a fun repair

Hahaha

#1 lawn care brand for the junior landscaper

*Powerful and strong>>>**t.co/TpCl72N0rQ** starts right up, a little big for someone who is 5'2" because you have to have your arm stretched out and can barely touch the controls. Permanent right-handed setup (just a comment, not bad or good). Lightweight and not much vibration.*

We changed belts that way 20 years ago . It works great . You just got to be safe doing it .

that's just sad I'm sorry also text me if you know anyone that knows about selling round ballers ok thx

How did you take to old lace pin out of the belt to seperate them

How did you take to old lace pin out of the belt to seperate them

I didn't know Walton made hydraulic fold tedders! Mine is hydro fold, but only because we made a think for it.

Awesome job! If you want the best prices and amazing belts from a US based company, go to www.americasbelting.com ! They also sell seed and fertilizer for your pastures to help you build the best possible outcome for your farming or Ag business needs.