- 7
- 9 375
Shelby
Приєднався 24 жов 2012
Gigabyte laptop prevent screen dimming
Disable battery saver in BIOS (F2 on boot in my case) in order to prevent screen dimming around 35% battery life
Переглядів: 11
Відео
Fix static soundbar
Переглядів 6 тис.Рік тому
Fixing static noise coming through soundbar. Swapping optical cord didn't help. Cleaned connector pins/leads with isopropyl alcohol & swabs.
4th Gen 4Runner Rubber Pad Over Latch Release Button Replacement
Переглядів 704Рік тому
4th Gen 4Runner Rubber Pad Over Latch Release Button Replacement Wear gloves! Kit I purchased: www.amazon.com/Release-Screwdriver-SEQUOIA-Liftgate-Replacement/dp/B01J4NAGP2/ref=sr_1_1?crid=3MRQJ9SFCM8TM&keywords=IE Works Rear Hatch Button w/Screwdriver & Screws Liftgate Switch Cover Compatible with Toyota Prius Lexus 4runner&qid=1668964334&s=industrial&sprefix=ie works rear hatch button w/screw...
2008 Toyota 4Runner Stop Switch Brake Lamp Assembly replacement VSC blinking
Переглядів 3262 роки тому
how to replace the stop/brake lamp assembly on gen4 4Runner part# 84340-69025. Mine came with extra "grommet" which isn't required FYI when this first started I pulled the original part out and put it back and the lights stayed off for an additional 8-9 months. When the lights returned I tried this trick again, however the lights would return daily. Just something you can try if you want to eek...
Cooling entire single story house/apartment with one air conditioner
Переглядів 6475 років тому
Tips on cooling a single story house/apt with a single window air conditioner
You don't show how to replace the part. You should remove your video, it's not helpful!!
Thanks! Wish you’d shown the filter change too though. I’m sure it’ll be obvious to anyone who works on these. Just trying to save time!
Oh. There is no filter. Well then, how much oil? 😂
Link doesn't work .
Maybe I missed something but I thought you might show how you replaced the part.
It was a complete afterthought to make a video, which I only did to explicitly state that you do need to pull the part out to replace the rubber gasket. As stated it's literally the 2 exposed screws and then prying out the 2 friction nubs and the part is exposed.
@@shelby3822were you able to use the provided screw driver? I kept trying but I wasn’t able to use the provided screwdriver in the kit get the 2 screws out. Going to try another low profile screw driver tomorrow.
Gosh damn I keep wiping my screen off when I see your profile pic lol.
How much btu’s do u have? U have to say how much btu’s to use because that is important in cooling a whole house .... not enough btu’s is not going to cool enough .. are u using. 18.000 btu and up?
This one is 5,000 BTUs
Noice.