Відео

Nah, you can have him back...😂

It's hard to say for sure, but it might. I would put the car up on a hoist and check the hanger positions. If they are in the same position then it will. You might have to tweak a bit. Good luck.

Joff Sander the mounting rods are identical. The xv muffler only has three and the brz has four but the the xv has four hangers so no issue. I had to lower the tips to go under the bumper otherwise you will have to cut your bumper. The last thing is the flanges are different sizes. The brz is a bit bigger. I had the back pipe from the brz too so I cut the flange off and used it. The back pipe does need to be bent out further to match up with the muffler flange just because it's a wider muffler. Hope this helps.

Thanks mate will look into it.....

Hi Ian, Did you replace the mid pipe resonator from Stock?? as in, the Hot dog or what ever its called in the US? is this the bit that will determine more of that Boxer Engine Burble??

+E. Y yes. the midpipe needed to bend more out towards the drivers side because the brz muffler is wider than the XV one. also the BRZ midpipe is about 1/4" larger in diameter so it's best if you have the BRZ midpipe too, that way you can use the flange that connects to the muffler as it's bigger by 1/4" too. Hope this helps.

+Iain McIntosh So the stock BRZ mid pipe will bolt on nicely ? Is there any welding work required ? thanks

E. Y Hi, there is some welding and bending because you need the BRZ flange at the muffler end but still need the XV flange at the front end.

+E. Y Sorry I only had the back section of the BRZ midpipe so I don't know if it would be a straight swap with the muffler.

+Iain McIntosh Also, no need to trim the rear bumper for extra clearance ? hangers fit perfectly ? Any loss in rear clearance compare to stock height ?