- 43
- 142 039
Newtonbrand
Приєднався 17 лип 2009
Відео
12390 Dual Drive Oxygen Sensor Switch
Переглядів 14711 років тому
12390 Dual Drive Oxygen Sensor Switch
39160 Fuel Line Retaining Clip Tool Set
Переглядів 1,6 тис.11 років тому
39160 Fuel Line Retaining Clip Tool Set
46600 Universal Inner Tie Rod Wrench
Переглядів 1,1 тис.11 років тому
46600 Universal Inner Tie Rod Wrench
39660 Transmission Oil Cooler Line Scissors
Переглядів 1,4 тис.11 років тому
39660 Transmission Oil Cooler Line Scissors
34350 Water Sensor Wrench for Duramax
Переглядів 15111 років тому
34350 Water Sensor Wrench for Duramax
couldnt get the fuel rail disconnected with regular plastic disconnect....ordered one to try out
What is the name of that tool
Lisle 39210
I need to do this on my 2005 nissan so I can clean injectors..only time I did this was several years ago on a chevy blazer,which I used a similar tool i bought..this refreshed my memory..know I got to see if I can locate the special tool I bought😢..thanks
I'm about to do my 2005 Nissa. Altima, just have a ? Was it easy too disconnect line with the tool. And did you have to release pressure from the line first?? If so where did you release the pressure. Thanks a lot. I really need get these injectors cleaned
The cheap tool i used did not work..i cut my line..i also got some gas spray in my face...watch a few videos first and you will be fine..Good luck
Je voudrai achtè la clè
When I put 1 hose on air leaks out of the other hose before I can hook it up to other tire
A completely unuseful video: outside the car, without any fuel/electric lines, and screwing cut!!!
on top of that the ring was not stuck shut like many lock rings are. it looks hand tight to me.
@@mr2law bho! I really dont' know what's the purpose of that video
Does this tool activate both brake chambers, or do you have to do one at a time??
This video was straight to the point. No intro, no long explanation, or self promotion. Just gave me what I needed. Excellent! Thumbs up
U can test the circuit without these jumpers tho, whats the advantage of have having them🤔
Not accurate unless the circuit is loaded.. this let's you do it yourself while it's loaded.
Very helpful video thanks
Could you maybe get it more blurry?
Why not just take a screwdriver and a hammer and knock it around?
That's ridiculous
Do not ever short out the power or ground on relay coil side from the break out pins which usually connects to control module or you will need a new module plus programming.
amazon
Does the lock on chuck lock onto DS-1 style valve stem caps?
Too bad there is not sound! What is the sense in watching this?
Do not follow this video. This was done wrong from the first step.
bought 2 first one came with extractor that would not start 2nd screw went in well then found out big threads striped and made screw go further down I am pissed looks bad try tomorrow
On a mission from God!
sick beer bottle-microphone..... classic.