Відео

There is no instantaneous processsing, real time means that it takes time. You only communicate when you have the token.

Great presentation

Fantastic explanation 🎉

Hello, can I get your contact number..

The flow rate directly influences the amount of energy required to compress a gas. By calculating the flow rate, engineers can determine the energy consumption of the compressor, which is essential for evaluating its efficiency. The efficiency of a compressor is typically measured by the ratio of the useful work performed to the total energy input.

Excellent explanation 🎉

What is PDTC?

Super

Good

Thank you sir

Nice Sir.I have one doubt.it might be chilli question.correct me if I wrong Why do we required here 230V AC Supply feeder.we are already converting the 24V DC supply in Power distribution panel and those supply we can use for IO cards and controllers right ?.If not then why we are converting to 24 VDC in PDP panel.where we are going to use?Please clarify

Thank you sir

Any software to measure...?

Excellent...can you add back Standards and P&ID/SIL so it can be a good references. Thanks 👍👍👍👍👍👍

what happens if we place dryer first and receiver last ?. means from receiver discharge its going to consumers, what will happen in this case?

Good explanation

Thank you. And I have one more doubt ,From this which one is highly efficient?

Sir,please explain about timers,how it used in instrumentation process,update more about instrumentation sir. And explain about logic diagram.

How to change the scale high SH in a faceplate?

Cryogenic control valve working and material yo be work video please upload sir .

Logic diagram also explain sir..

Thank you,expain in pannel side live,it will be more usefull..

Thank you for the great explanation. I have a question, please. What will happen in the condition of startup? which is normally will be lower than the Low Low alarm.

thanks

Good video

One of best tutorial Sir really impressive I subscribe your channel

Very Good Content 👍

Very Good 👍

Excellent video, very informative sir. Keep going 🎉🎉

Please what does DL and VL stand for?

why 60 farenheight is considered only ?

Do you have a module on how to creat a out of range alarm

thank you

Thanks

Best video sir

Good explanation sir, good English accent just keep on. God bless you .

The last position of this video need improvement, which it is not plug which is shown in this video

Please make a video on HIPPS(High integrity pressure protection system)

I need clarification, which is the higher pressure drop across the valve, 50% open or the 100% open.

Tamila video podu ga anna

NR ?

Thank you 🌹

Thank you. This helped me!

Hi, is this same as Zero power condition ?

Thank you

Control valve coefficient should be low or hight?

Thank you for the informative video, I can't seem to find any good resources for this. Is there any other videos for cause and effect sheet, or any good resource to read? Any help is appreciated. Thanks!

On what basis selecting the solenoid valve power rating?

Thank you. Well explained.

What is the benefit of LCV over VFD