- 16
- 49 099
TheSpookable
Приєднався 11 лис 2013
LIFE OF A JOBLESS DUDE
4AFE overheating
Tried replacing head gasket with no luck...
possibly head needs resurfacing. Will update soon.
possibly head needs resurfacing. Will update soon.
Переглядів: 408
Відео
4AFE brief idle hunting
Переглядів 1,3 тис.Рік тому
Listen carefully & notice the random idle hunting... I've already replaced the MAP sensor, cleaned the throttle body during the video record date. Days later, I replaced the coolant temperature sensor and the issue has gone or happens extremely rare.
4JG2 EFI Throttle Pedal view
Переглядів 214Рік тому
Visual inspection before installing... this stuff is pretty hard to find even for a used one with a reasonable price. 2nd unit with marked 'OK' is the purchased unit.
4JG2 EFI Startup test after TPS pedal replaced
Переглядів 876Рік тому
Replaced the whole TPS pedal unit (not top of fuel pump). Better response and no more check trans light.
4JG2 EFI "Check Trans" flashing
Переглядів 5 тис.Рік тому
Problem started with brief flashes and progressively getting worse with constant flashing and no overdrive.
4JG2 EFI ECU Problem #2
Переглядів 13 тис.3 роки тому
From the #1 video posted, this is another different ECU which also emits roughly the same problem. The capacitors are also swapped out with unknown brand but low ESR specs. Except this one doesn't knock loudly during startup. Idles fine for few seconds/minutes. Revs up and die.
4JG2 EFI ECU Problem #1
Переглядів 11 тис.3 роки тому
The ECU's capacitors has been swapped out with new unknown brand with low ESR specs. Unfortunately, it knocks during startup and only idles smoothly a few minutes and will eventually turned into the following video. A faulty NP Sensor may also replicate this kind of problem. But in my case, the NP Sensor is known to be in good condition with cleaned connections
Toyota 2L-T Startup after replacing engine head
Переглядів 1164 роки тому
head replaced with a non-turbo 2L head with some mods to the exhaust port bolts to fit in the 2L-T exhaust manifold. Basically did top overhaul and starts better...
Toyota 2L-T Cold Start (1 bad injector + possible engine head issues)
Переглядів 1584 роки тому
this is why you should never skip top overhaul while replacing piston rings
Toyota 2L-T Startup after replaced piston rings
Переглядів 1324 роки тому
Toyota 2L-T Startup after replaced piston rings
Umbalan ku suminding
my car is Isuzu bighorn 3.1D
Did you fix this issue?
i have changed all sensors (iacv, map, tps, ect) and still does not solve. I think the last sensor i will be changing is the O2 sensor.
My bighorn 96 4jg2 same like this, what is better solution Bro.😢help me
@komyatzawwin8351 try cleaning/check ecu wiring and harness to fuel pump. if all ok, last option is to try replace ecu
My 94 4jg2 is starting then turning off tried to hold revs up to 1000 but no luck turned off now not starting at all aint my starter it def get no fuel 😢
It’s 3.1 original automatic transmission??
yep
I replaced my whole gear box but my bighorn still doesnt move, whats the problem?.
is yours auto? because bighorn autos usually have TCU located under the steering column. It won't move without the TCU plugged in.
Yes mine is auto, i will try to find that TCU and locate it myself to see before calling any mechanic to come see. Thank you so much 😊
Kounsikou Sinding karaoke Tobpnai.Onsoi.👍
My 93 4jg2 doesn't have a computer and idles like that when there is air being sucked into the fuel line/filter. Try bleeding the fuel filter.
T-stat stuck closed.
I think it's the head gasket
Какая ошибка? Какие симптомы акпп?
здравствуйте, я использую Google Translate. Симптомы: лампочка беспорядочно мигает. при нажатии педали газа лампочка перестает мигать. если лампочка мигает, автоматическая коробка передач не переходит на 4-ю передачу (повышающая передача)
Hi how did u solve this problem, do u know a way to reset the ecu
hi as of today, i still don't know how to reset the ecu. I only replaced the ecu
Hey wondering where i may be able to locate the ecu? Mines the 96 wizard same motor but no intercooler, unsire if mine is efi or not. Im having similar issues
usually the ecu is located inside the center console. gotta remove some interior bits to get to it. verify first whether yours is efi or not. you can tell by looking at your fuel pump whether it has just a black box on top of it(efi) or it is attached with cable (non-efi). i think some efi models have cable attached with sensor attached too. else, you'd be wasting time searching for an ecu.
Did you find the problem? I have the same problem
i still don't know what's the exact problem because now it rarely happens after i change the coolant temp. sensor. sometimes it idles constant at 1k rpm. Maybe i'll check the ecu someday.
@@broes1 thanks mate, i can't use my car, it is really annoying its always stalls
@amarbautista6783 have you tried changing map sensor & cleaning the iacv valve? if it stalls then its a bigger problem
@@broes1 hi sir i solved my problem, the injector socket plugged in opposite in injector number 3 and 4, i swapped the socket and voila it it totally fine!
What happened to the issue How did you get over with it
Sorry for late reply. I replaced the ECU unit with a used one.
My 1997 Bighorn 4JG2 used to do that - I sprayed clean the filthy wiring harnesses over next to the fuel filter with electrical cleaner and that fixed it. The wiring for the EFI part of the governor runs through those harness plugs.
all good, mines like this fot the last 100k
yeah it doesn't affect much on daily driving until i'm on an open highway with no overdrive 😂
How and what to fix the problem mine will be blinking after a few meter drive and seem noforthgear and also when turn on the od button nothing happens.
21 error?
@KM Garage Melai i'm thinking of replacing the throttle sensor at pedal. i'll update in couple of days.
@@александрмакидонский-в7ш i don't know how to check error codes for 4jg2 efi sorry
Replace the RPM sensor .thats it
We have same problem
Can fix
Can fix
my bighorn does this, it is the np sensor i soldered the connections back together but i still get the same issue. Do you know how to reset the ecu?
Isuzu bighorn 1996 subic converted right hand to left engine number 4jg2. Does anyone know what the part number of the computer box (Efi) ,is? If brand new with warranty , will buy .
hi, in my experience, the part number for 4jg2 efi computer is different but it should plug into any 4jg2 regardless of countries. mine was 897149-6210. I dont think they have brand new with warranty anymore
Do you have facebook so I can add you and contact you there?
Same issue with mine. But I have no check engine lights coming when ignition on. Sometimes it will show up and fires up. I saw Your thread on clubisuzu and got me here.
My favorite diesel engine