Відео

When it gets converted into a ski jumping hill, another Janda shall dominate. Alexander Janda!!!

and every event they ever had was shortened or canceled by the wind. A ski flying hill on top of a hill next to lake Superior will never work, and never has.

Absolutely amazing! Our sponsor has talent, folks!!!

Excellent! Was up on top in the summer of late 70s , could see across Lake to Canada! Retired from Ski jumping after witnessing two Canadian jumpers were paralyzed at Copper Peak, early on take off, somersaults onto back, neck at impact, retired 3X junior Canadian Champion! Sure Richard Grady from Edmonton Alberta Canada was in these clips, after mentioning wind tunnel.

Great cuts and material. Thanks

How many pound tow strap

That looks fantastic. What paint are you using. I'm looking to buy a Catalina. A few pop up from time to time.

🔥🇺🇸

Thanks for the video. I want install a set of these Super ATV wipers (driver & passenger) on my 2024 CFMOTO UForce 600 that has a Super ATV Full Size Lift (Polycarbonate) Windshield. Trying to decide which size to go with for best fit and installation. Could you tell me what the full length of setup is from the tip of the blade with the handle installed on it, to the hole where the handle will be mounted? I'm think I will need a "Medium" with 13.75" blade with a 9.84" arm. Thank you.

Hey I’m loosening the nut but it’s not getting loose and is turning the damn screw with it pls help

Awesome test 👌. Tempted to try this with 27s

Thank you sir! 2020 Honda P.500 alot better. Read how to do it, but needed visual to understand haha

Which app did you use for tach in video?

I use synthetic rope with a roller fairlead. Been using the same setup for four years and have never had an issue.

Almost the double in size of a olympic hill. In 1994 in Lillehammer they set a new hill record 135,5 meter, and the hill record in Copper Peak is 158 meters. So, no its not almost double in size. And the record in the small hill in the olympics in 1994 was 104 meters. The hill looks like a difficult hill to jump in, you dont seem to get much heigt, sy you really must work.

I won 4 years in a row.

Been searching for about 30 minutes and didn’t find something that was what I wanted. This is it! Good stuff.

This was extremely helpful. Thanks for taking the time to make the video.

Are your KC light covers the 5” model

I had older Polk db 6x9s in van on 125wrms, I think they need more power.

any way to reset?

Good job. Did you notice any difference between the Uni and Yamaha filter?

Great video. What carb kit did u end up buying for it in case u needed something? Just curious for future rebuilds. Did u end up using the same float needle or a new one? Thanks

I find breaking those pins loose before you remove the caliper makes it alot easier

I like this idea w/the tape & friction - I have atv winch on blazer for snow & strap broke @ both ends - I realized buddy had riveted it on @ spool end - just allow myself extra strap...the actual replacement strap is on 24'' & they want $50 for it lol

Can you tell us what needs to be turned on or off on the garmin for the best results thanks 2:14

The Upper Peninsula of Michigan , WE ROCK !

Wow! Thank you so much for posting this video! I had seen vvmapping before but I didn't really understand what it was or how to use it. Like you said, cell phone coverage (especially here in northern Michigan) is spotty so I couldn't get much use out of the apps that I was trying to use. They have really opened up a lot of roads for ORV use here in northern Michigan which allows you to travel from one ORV route to another, or to town to get gas or food. Knowing what roads are open right there on the GPS is fantastic! Even when we are riding just the ORV route, it's very easy to miss a turn and get off track, so it would be nice to have the GPS. I just ordered a Garmin Drive 52 for $99 and the SD card from vvmapping for $40, so it is a much cheaper option than other GPS that I was looking at. Thanks again for sharing this information, I can't wait to try it out!

Quite resourceful, integrated door design is brilliant and handy

ps u cant use to winch out if stuk on n angle now right?

how can som wet snow brk the rope, its meant to take thousands of lbs...???

So, how did the roller fairlead work out, with the strap, over the long-term? I just replaced my steel wire cable with a 10,000 lb strap (keeping the same roller fairlead, but polishing the rollers smooth for the nylon fabric) because I was tired of repairing the winch cable. Just tried it out and seems to work fine so far, other than the strap sometimes gets off to the side of the fairlead, which looks like it might chew up the edges and wear that out prematurely.

Seems more like the machine can’t spin them fast enough. Wrong tires for that underpowered cow. Wheel speed is everything in soft sugar sand

nice eml !

Those 2 D rings are called shackles. D rings are different.

Have the tow strap snap yet and how is the tow strap holding

Are there no grease fittings anywhere on the front end on the X4?

ua-cam.com/video/12B13_QnhdY/v-deo.html Not HARRICHOV, but Harrachov; and not Slovakia but the Czech Republic.

Good fix.

Thanks for the info. I do believe this is in my future.

What I like is you have several options so you don't have to stretch them out to much while stored.

Thanks for this vid! I am in the process of upgrading my Pioneer 1000-5 and have the SATV Flip-up windshield to install. Was trying to figure out what to do when it rains and snows, now I know.

I wished I would have watched this a couple of hours ago. I had a pain in the rear installing my strap, where I used a rope through a loop end , and then hog ringed the two ends of the rope together. I had a hard time getting the rope into the winch and then to tighten it. Oh well thanks again.

I hate Weavy Het Snow!😂

My bike will only rev up with the chokes on, it won’t rev with them off. It just goes blahhhhhhhttt and dies. The plugs have always been very sooty and black, which tells me it’s too rich. Since the Mikuni starter circuit is different from a standard choke, is it giving me more air to the mixture while it’s on and throttle opened? Which is why it can then rev with the choke on? With the throttle closed, it will barely idle with the starter circuit on. Been chasing down the tuning with these carbs for weeks. Air screw is almost falling out to achieve a rise in rpms; I have smaller pilot jets on the way. Any help would be greatly appreciated. Honda 400cc with Mikuni VM 32’s.

What about o rings on paper filter?

So I'm considering a flip up windshield like yours or a glass one .. how do u like that windshield? Does the windshield stay up and rattle ?

Do you still have the 3 wheeler?

imo yamaha should've used the clutchless semi-auto they got on the yxz1000. such a great system and much sportier to ride with better sound, especially with the 2 cylinder, imo.

Thank you