Відео

THANK YOU!!!! Finally someone shows the passenger side! You will save me time when I replace mine. Love you called them “beauty covers” 😂😂😂😂

How did you get the water sprayer arm off?

You can get the passenger side without taking inake off. You just have to remove plug wire on #8 to coil. Then you can slide downward and out. Becareful of upper heater hose T connector, by firewall, it can easily crack and leak.

it needs to be done with tires on and weight of truck on front end

Defintely take out the fender wheel liner on the pax side of the vehicle. I did the driver side with not too many problems and hell i got big hands. lol

Retard

Best video I have seen in a while tha ks for covering the whole job.

Sound like a nightmare! God bless you! 😊

I did fail to mention. Before I put the bonding tape down, I did end up doing a little extra cleaning in those areas.

Please help me because I can’t break it/remove it

The work truck getting tuned up nice 😹

Hey you don’t have to remove the bumper in order to remove the Rear bumper pad.

Pretty sick

Great job! 😻👍

How do you get the passenger side cover off

This is anything but informative. I would have been nice see you disconnect the coil connectors. Literally that is it. Everything else is BS

Pins will wear off in no time, I replaced mine multiple times. Im thinking to drill new hole fir a pin or bolt, so it won't be under the bushing. Bad design.

Good job with the alignment, now work on your camera skills 😂😂

I have a 2008 silverado 2WD and i want to make a 4x4 floor shifter convertion and this video and the other video help me a lot thank you very much Can you make a video testing the 4x4 driving or in snow or mud

In the silverado is the same light indicator to 4Low And 4HI But only in 4x4 floor shifter in the electric one doesn't have ligths indicator

Can’t see anything

Coil still running

I was thinking about the dirt king but was wondering what would happen if the alignment calls for the alignment pin to be placed in between the holes?Better concept though than stock.

Please please get your wife to do the video. You were constantly moving the camera making me nautilus, lol

Fuel tank pressure sensor

f me get to it

how was it after you used it again?

Work on ur camera skills before postin a video. This video sucks.

You can purchase the VVT pre filter screen/bolt assembly, as a genuine parts from Hyundai. Mine got destroyed removing.

Thaaank you!!!

This solved my issue as well as topping off my oil as it was slightly low. Thank you so much!!’

Can you show us how you cleaned your dishwasher pls 😭

I don't remember which number of fuse I used, but it was the fuse box under the hood that is on with switch power only.

Thanks so much; I have exactly the same problem... bought a Grand Highlander but did not have backup sensors... adding 8 sensors (front and back) but had the same problem... the back sensors were too short. I was concerned when the wires were coax type of cables instead of a twisted pair which is what I expected. Thanks so much, this is Great!

I’m going to try this!

Thank you was wondering why it wouldn’t just “ pop up”

Thanks for the video. Very informative!!

If you can show the stuff you saying I’ll be fine to see it

bro, that is not a ProMaster. that is the ProMaster City. little homework would help yeah and they are a pain to change the lights but pretty straightforward

Did you finally get the situation resolved? And also did You smell gas fumes walking by the truck

Thanks for the discussion on the passenger side "manifold cover" part, I also saw countless vids on removing the driver's side cover and was hoping that I could just pop off the passenger side cover and knock that side out in a few minutes, but doesn't look like that's the case. Sounds like I'll need to carve out some extra time to remove the cowling... Very helpful, thanks again.

Hey bud do you happen to recall where the hell that driver's side temperature sensor plugs into the HVAC box?

Just did this! Thanks so much. After watching your video I was able to take it apart and replace the boot pretty easily though now I'm probably going to have to replace the tub front too since it cracked. Great video about what to expect and how to get at it.

Wass up with them Coil Packs Tho 😮 ?

Yes, LED's.

They must be LED's and diodes only flow current in one direction.

Did the charcoal filter fix this?

Unfortunately, that's the sin in my eyes. I did not get the pouch.

The coil packs were kind of rectangular. And yes I am satisfied with them. I have not noticed any significant increase or decrease in power or gas mileage.

No.