Hi My D5 evo's motherboard reset and then don't save the limit setting, its starts and run the slowmo section and as soon asgo over to fast mode it reset and nothing is set, is it motherboard or battery
Do you know what is the standing current / consumption of the control circuit is? If I charge the battery from a PV and a charge controller only, would that be ok in terms of the 7AH of the battery?
Hi Mr Gate, I am loosing batteries way too soon. I am assuming that the load shedding is playing some role in this, but the battery charger also seem to overcharge the battery for long periods of time. Does it have a boost charge function related to loss of mains?
Hi its a big job only of you know tech then you can do it ,the unit has to cone out ,open the outside gear then in front remove 4 screws remove the knob then pull the whole shaft ,that's it
Hi My D5 evo's motherboard reset and then don't save the limit setting, its starts and run the slowmo section and as soon asgo over to fast mode it reset and nothing is set, is it motherboard or battery
How to change charger, replace. ?
Thank you
I got 13v on my battery buts keeps telling me low battery when operating then stalls. Got to wait for about 20 min before trying again.
Thanks is very helpful
Do you know what is the standing current / consumption of the control circuit is? If I charge the battery from a PV and a charge controller only, would that be ok in terms of the 7AH of the battery?
Hi Mr Gate, I am loosing batteries way too soon. I am assuming that the load shedding is playing some role in this, but the battery charger also seem to overcharge the battery for long periods of time. Does it have a boost charge function related to loss of mains?
My gate is always saying battery low when I close or open it
What could ot be I mine does not go up to 14? Is it not charging or something else as I just replaced the battery
does anyone have a video of how to replace trhe oil seals? its coming to the doss section
Hi its a big job only of you know tech then you can do it ,the unit has to cone out ,open the outside gear then in front remove 4 screws remove the knob then pull the whole shaft ,that's it
@@nashbharosa9965 thanks, i think i've seen one video.i will manage it..will give it a shot
is 11.9v ok?
That gate is like a coal train going past! And as long! 😂
My Battery and charger voltage drop to about 10.5 and then switches off. Could that be a charger issue or battery issue?
Setup fails no origin found
Please add more help videos.
Thanks for this. I was going to whip out my multimeter but it seems thanks do the Evo5's clever design it's much easier than all of that.
Or rather send me Your email address Thanks
I love you Mr Gate. This video helped me so much, you biscuit!
Please do a video on changing the battery
good day can i get your number need some advice
How i connected a d5 evo to light i do not understand the diagram
hi ? my gate has a problem it go down and up continuously none stop, what is the problem?
Hi, if the battery if flat, how long will it take the system to fully charge the battery?