- 34
- 75 058
Christopher Berube
Приєднався 4 вер 2009
'09 Yukon Denali - resolved issue with hot positive battery terminal.
So, after running all these temporary grounds and alternator charge cables, testing this and doing that in the end it turned out to be the battery.
Переглядів: 52
Відео
1992 Chevy S10 paint prep
Переглядів 365 місяців тому
Getting all the rubber trim and adhesive removed.
1978 El Camino - Rub Pad Free Front Bumper
Переглядів 426 місяців тому
Just going over some of my latest upgrades.
2009 Honda CBR600RR restoration.
Переглядів 60Рік тому
I've finished up all the things one would typically do while the fairings are off while repairing this and that. Mainly seeking opinions on if I'm missing any fairing mount points, otherwise it's getting there!
Electric vacuum pump for engines with low manifold vacuum.
Переглядів 234Рік тому
Here's a link to my build sites.google.com/view/cwberube/el-camino-engine-bay Parts list shown below which might help someone current day. (9/2022) The Hella Solid State Relay wiring differs slightly. Using a standard relay harness your fused\key on power 12v supply will go to pin 30, the output 12v load is pin 87 (this is the feed voltage to the pump). You will provide a constant ground to pin...
'78 El Camino - Daytime run
Переглядів 1202 роки тому
A daytime run after work to get the new choke adjusted.
Ellie night test.
Переглядів 282 роки тому
Fixed that stinking intermittent starter bendix chirp. Ready to roll on out.
1978 El Camino 305 V8 open headers.
Переглядів 4,4 тис.2 роки тому
1978 El Camino 305 V8 open headers.
Duel of the Black Drum - Escambia River Pensacola, FL (10/1/2021)
Переглядів 592 роки тому
Duel of the Black Drum - Escambia River Pensacola, FL (10/1/2021)
Office trash panda hiding from the rain.
Переглядів 565 років тому
Office trash panda hiding from the rain.
6-16-2018 Fort Pickens Pensacola Florida
Переглядів 936 років тому
6-16-2018 Fort Pickens Pensacola Florida
1987 R10 SBC Thrush Welded Exhaust (Carb Conversion)
Переглядів 9627 років тому
1987 R10 SBC Thrush Welded Exhaust (Carb Conversion)
Deadman's Island - Pensacola Florida
Переглядів 1,7 тис.7 років тому
Deadman's Island - Pensacola Florida
Awesome.
How?
Nice work Chris it's looking good!
Yeahhh buddy!!
Thank you. I need to make a proper video of it current day. It sounds epic with the new 3" longtube headers, to straight pipe duals, to 3" Flowmaster FlowFX bullets. Pretty sure I have one on my channel but only a 2k rev and idle. I'll try to make a good one this weekend with the cruck in motion getting it.
Jesus, any mods?
Yeah, it has a 450 HP \ 471 TQ - Blueprint 383 engine. That pull wasn't even more than 3k rpms, maybe 1\2 throttle. I'm just about to install my freshly built TH350 and Ford 9" with TrueTrac posi. I'll make a new video once I have all that hardware past the break-in period. I don't want to hurt the 45-year-old original transmission and little 7.5" open carrier rearend.
@@TheExBx oh ok, even better
What headers are these?
😮
Any update I’m in the same boat as you
I finished the rebuild. What do you need to know?
@@TheExBx where do you get the missing bolts from? Idk where to start
I want to know where you got all your parts
Which parts are you seeking? I sourced them from multiple companies.
Did you have issues installing the headers
Love it I mine is original 2.8 I want that 350
It's nice bro reminds me of one of mine I had in the 90's. U get chance take that bumper off and get u a fiberglass roll pan for the back, it'll look a lot better. Also put that monster tech on the can frame between the drivers window and the front windshield that's where they look the best. Love the truck.
all about opinion bro some people like different things
Weres the fan
how u liking that motor ? I'm loving mine !
Seriously love it man. The engine runs so well and is an absolute powerhouse on the road. Can't wait for the 500 mile break-in period to pass so I can give that throttle a good punch!
@@TheExBx oh man mine seemed to just get more power after the 500 ! I just Installed a 700r4 also and it's amazing ! sucks running 93 gas but it's worth it !
@@TheExBx I can't get mine to go higher than 170-180 degrees tho ... when idling it'll get to 190 .but I have a 190 Stat so not sure y it only stays around 170 to 180
@@PeachCoastLowrider you're spot on about the high octane fuel but I don't daily this car so not I don't feel it that often. I wouldn't mind a 700R4 swap but it'll be a bit. Still have to build up the rear end. I'm sporting the stock 10-bolt 7 1\2" non-posi which will never last if I try to make a serious hit once in a while.
@@TheExBx yeah man surprisingly my stock rear is holding up ..I don't do burn outs tho .. it's whatever is stock ,I'm not sure ? 63 impala. it's non posi as well. I'm assuming 10 bolt?
Nice! Hope you still have it.
You have a loud vibration noise coming from the bed of the truck. I have the same issue with my s10. Do you know what caused it or did you by chance have open mufflers under the bed of the truck?
Stock 350 really
What kind of mirrors are those on the doors I'd like to get some for my S10
How did you get the 92 cluster to work in a 86?
"This is a no bullshit fish, dude." 🤣 Well done. Good fight. Good camera and net work also!
;) thank you sir!
what rear suspension are you running, i like that ride height.
I think it's stock with bigger wheels
My G-G-G-Grandfather, Captain Jacob Brown, owned that ship repair facility. "Deadmans" were the huge brick weights that were located in the shallower water offshore. Ropes were routed over the boats being repaired, and pulled from the shore side, to roll the ship over on it's side, where the hull could be repaired. Then, the boat would be righted, turned around, and the whole process done again to the other side of the hull.
They may look like cute little bandits but they can be very destructive. They carry all kinds of pathogens, one is a deadly to humans brain parasite.
Its raccoon you dum* do you go to school or you just don't know what is raccoon
Yall call raccoons trash pandas?
they do kinda look like pandas
I thought it said Trisha paytas breaking in your house and I was so let down when it was a panda 😪
What cam?
Just a good old E303. Ford Performance M-6250-E303
What motor?
I want that
Mods?
now LS swap it!
Christopher, Was this on the gulf side or sound side? Thanks.
Yes this is on the Gulf side. Unfortunately most of these reefs are covered in sand since last season but hopefully it will clear out soon. Still a great dive.
What is all the noise
Gear Drive, it replaces the timing chain with a set of noisy gears.
Christopher Berube. Great '86 s10 350. What trans, diff? Please check out my '89 s10 on youtube (maniacal s10) 21 vids thanks. Mike.
What size belt and what brackets and pulleys
what size are the wheels on the back
Que medida las llantas????? por favor...
She's clean hoss! very nice!
how much did you invested for a 350 conversion?