Відео

Now we have a lot of RWD kit on the market... ;-D

恭喜頭香... ;-D

Anything is possible... ;-D

Yes, especially when decelerating, blue smoke can be seen in the mirrio.

Sorry dude, I'm still learning Solidworks and my design sucks. I'm not ready to share my lousy blueprints. Maybe one day I will go back to retouch it and then consider to upload to Thingiverse.com, Thanks!

谢了

Fully charged 2-Cell LiPo battery voltage is about 8.2v to 8.4v. Make sure you don't discharge it lower than 7.0v it might get damaged. For storage, 7.2v to 7.6v is pretty safe for a lomg time, I mean couple months not using it. Hope it helps.

Futaba 4PK compatible receiver. It was designed for 1/10 RC car but small enough to fit in Mini-Z car body. ua-cam.com/video/9WesLPzpGDM/v-deo.html

I just ordered the FS-GR3E, do you think it will work with the GC301?

@@Trifle165 I guess it would work just fine. Be sure to test the whole system before installing.

Sky RC GC-301。1/10漂移車用的陀螺儀，我裝在Mini-Z上。

Sorry dude, I'm still learning Solidworks and my design sucks. I'm not ready to share my lousy blueprints. Maybe one day I will go back to retouch it and then consider to upload to Thingiverse.com.

www.oh-model.com/ or search key word: Orlandoo Hunter These ball ends are for 1:35 R/C model cars

Hey Tom, It's a 3D-printed chassis based on the MR-02. The design of the steering system was copy from my 1/10 RWD drifting RC-Car. The front shocks were borrowed from my 1/35 rock crawler. The rear shock and gear box remained stock. I installed my own servo, receiver, ESC and Gyro. And a Li-Po battery small enough to fit in was not easy to find. This project is still ongoing and I'm working on the gearbox now. Need a higher gear ratio to slow down the wheel speed and easier to maintain motor speed. Please take a look at my another video and you will see the chassis without the car body. ua-cam.com/video/3ckkPgdWKmg/v-deo.html

That is absolutely awesome, well done, I wish I could get my hands on something like that...... it looks like awesome fun, keep up the good work geezer,

Nice work man, would you mind sharing your Printfiles? Would love to build one of these.....

I haven't finished the whole project yet. Some parts are still needed modification. I will post the STL files after it is done. Thanks for interesting in this little drifting car. ;-)

it seems ok for me what you have done so far, could you send me the stl files from the state is was in the video? seems good enough for me^^

+蘇馬赫 1/10 居多。