![Smokinjoker87](/img/default-banner.jpg)
- 5
- 106 196
Smokinjoker87
Приєднався 12 січ 2007
How to install headlight wig wag system
head light wig wag flasher system install. any questions just ask
Переглядів: 99 700
Відео
2001 Tahoe Soldier Escort Vehicle (Lights during the day)
Переглядів 83212 років тому
My truck showing lights during the day.
1998 Blazer Headlight and Tail Light Flasher
Переглядів 1,9 тис.12 років тому
SO SORRY FOR THE MUSIC NOT MY CHOICE IN MUSIC
My 2001 Tahoe Soldier Escort Police Lights
Переглядів 3,4 тис.12 років тому
2001 Chevy Tahoe. Installed is a Galls headlight flasher, Galls Traffic Backer, Galls Dual Dash Light Strobes Single Strobe in the side windows, and Galls arrow stick. Also have something else but you will have to wait for that video. Will post a video of lights in the day time also.
You can't even see anything with how he is handling the camera
Da hell you use all that shit for?
How do you adjust the Flux Capacitor?? Asking for a friend...
Useless..
Whis diode you use?
The diode is causing your low beams to come on simultaneously if I'm not mistaken, this is also how folks achieve the FTDTDRL mod which you can read about online. I bet it you pull the diode you wouldn't have to do that hack job work around to get your low beams to cut off, otherwise decent job
Clear as mud, just like every other f***ing wig wag video out there.
I have a negative switch wig wag federal flasher system . I am trying to install this dam thing on my f 450 truck and I kid you not this piece is not co -op- ing . If you have any idea and have a little time would you be kind enough to briefly write a little instruction text ,thanks.. much .
lol fuck yea marine corps
Normally the red wire goes power all the times black wise ground Orange is the power source the one that come from the switch Blue and yellow is the ones go to the headlights
You made this confusing AF.
WTF DID I JUST WATCH HELP ME LORD
my wig wag has a switch, four colored wires, and a red power wire. I have it hooked up to my fuse box near my pedals, and and connected to 4'' LED running board lights in my front bumper. It wont work. whats wrong.
Can you do this on a 2013 Chevy Camaro. Mine has agency xenon lights though. So they kind of look like magnifying glasses
If you have HID lights. Wig wags will not work.
I have the same car, and I have that stupid on-star thing that doesn't work any more. Can I take it out? I want that space to do something. Idk what yet, but I want to take it out. Can I? If so, how? Thanks!
You're an idiot.
if the switch panel is still in the Crown Vic then the wires are disconnected in the panel. if you need a panel try looking on fleetsafety
How you make the lights do that
A Flasher Module...
thanks for the vidio, lot of help
i have an 02 suburban
01 tahoe negative or positive switching?
His is ground side switched he says that in the beginning when he shows the wig wag unit
damn, im tryin to install wig wags into my 2002 suburban and you lost me quick. Is there just some basic simple set up I can us? or another recommended system like federal signal or some shit?! lmao
Pretty nice setup, Is that the federal signal PA 300 sieren controller. I have the Code 3 Mastercom B which I baught on craigslist for $50, Has siren and light controls built in as well as a PA with a volume adjust.
So was it hard? do you have to run a wire from both rear tail lights to the box?