Відео

Error type D08: Master making unit not set Error point 224: Master making unit is not set (both the safety and lock sensor are OFF) Try this: Set the master making unit in place.

1. Remove all paper from feed tray 2. Let the tray go down to the start position 3. Switch off device 4. Clean Stripper Pad and Pick Up Rollers 5. Replace Paper and Re-test 6. If error persists replace pick up rollers and separation pad

Check the paper tray area. if the machine was recently moved, make sure the plate under feed tray isn't bent. there are safety switches above and below paper tray, that is where your problem is

Contact us on WhatsApp 072 157 2681

B-positioning sensor status does not change even after 3,033 pulses after the main motor activates.

Please contact our support group on 072 157 2681

Good day please register on our support group for a solution to your issue 072 157 2681

Печать на листах А4, лист формата А3 занял бы всю длину лотка подачи бумаги

If you can run the main motor by pressing the switch on the main board or in service mode 880 and everything sounds and moves good. I'd take the main motor out of the machine and crack open the sealed cover that goes over the encoder disc, enough dust in there would throw this code. Or the main motor is bad. It's not that hard to do but you better know where all your timing marks are and have some jigs to lock them down.

How to open the main motor?

Yes we provide device support in South Africa

I am talking about Surat Saher in India, I used to have a machine from a surat dealer, but zero on the name of service.@@southbisonoffice

Contact our offices on +27 72 157 2681 for device support

Contact our offices on +27 72 157 2681 for device support

It means either that the ink tube is incompatible or the code at the bottom of the ink tube has been damaged, so the machine is unable to read it. Step-by-step: enter Test mode by holding down left and right position arrow keys and turning on the machine when the error message D04-534 shows, press yellow reset button press ‘C’ on the number pad enter 890 and press Start (green button) when the machine beeps, press ‘C’ on number pad again and enter 112 when the machine beeps again, press yellow reset button and hold it down, so the machine will reboot

Contact our offices on +27 72 157 2681 for device support

Communication between the board and screen interface needs to be investigated further

Thank you, we are passionate about youth capacitation

Contact our offices on +27 72 157 2681 for device support

Good morning

Yes this social impact initiative is available for implementation in all African countries