![Shawn](/img/default-banner.jpg)
- 2
- 11 901
Shawn
United States
Приєднався 19 жов 2012
This is my project channel for items I have made for fun or selling on amazon and etsy.
How to change garage door rollers on the bottom safely
When removing the bottom roller bracket you have to be careful because of the tension cable will pull the bracket off and make it impossible to get back together. 
Переглядів: 2 952
Відео
2015 F150 2.7l Engine coolant over temperature
Переглядів 9 тис.2 роки тому
Fixing the engine coolant over temperature error on a 2015 F150 XLT 2.7l. Scanned code P1299 in this instance. Check if this is the only code, if so you need a cylinder head temp sensor. Remove engine cover with two 10mm nuts, use a small flat screwdriver to unclip the 2 wire connector, use 19mm wrench to remove the old sensor, put the new sensor on hand tight, and clear codes. You will need to...
Will this problem cause the truck to go in limp Mode and lose power
Yes
@@Shawn-ph6ys so I didn’t blow a head gasket
@@Shawn-ph6ys and that’s man you are a life saver , just hope I didn’t blow a head gasket , it happened an hour after my oil change
Hopefully it fixes your issue
Mine is reading a p0128 and p1299 changed out both thermostat and cylinder head temp sensor and nothing gauge still goes to hot as soon as truck is started but not getting hot also ac doesn’t blow cold and truck is in protective mode if I clear the code everything works fine for a few minutes then check engine light comes back on
You will have to get a scan tool hooked up that can read the sensors individually. If they are reading out of limit or something high then you can spot the issue. Most likely you will need a dealer or a small repair shop to find your issue.
What the fuck was that? This is UA-cam rape, you don't deserve a channel and your 7 viewers need their 30 seconds back.
Ready for it. Thx. for my 2015 2.7 XLT EB