- 9
- 335 527
George Kenny
United Kingdom
Приєднався 15 вер 2013
Відео
38mm Pool Pump Filter Heater setup for Karen
Переглядів 3,2 тис.2 роки тому
38mm Pool Pump Filter Heater setup for Karen
Gardena Grass and Leaf Collector UK
Переглядів 56 тис.2 роки тому
A brief review of Gardena Leaf and Grass Collector here in the United Kingdom in Autumn fall.
Knightbridge LED ground lights patio install LEDGL3W
Переглядів 53 тис.3 роки тому
An install of knightbridge LED ground lights into a concrete patio. LED patio lights LEDGL3W with 78mm drill out
How to wall mount a SONOS BEAM
Переглядів 73 тис.6 років тому
Surface wall mount a SONOS BEAM with the official SONOS BEAM wall mounting bracket accessory.
Plantronics Voyager Focus UC versus Jabra Evolve 65
Переглядів 77 тис.7 років тому
Quick review of two similar, mid-range UC bluetooth headsets.
Motorola MBP854 Connect review
Переглядів 45 тис.8 років тому
Some annoying features of the Motorola MBP854 Connect.
Maxi-Cosi Assix Fix Versus Nuna Rebl
Переглядів 22 тис.8 років тому
A short critical review of two UK available car seats. Non sponsored video, this is a review from a real Dad after using both car seats equally across separate cars for nearly 18 months.
Do you think this would pick up leaves from a gravel driveway?
how do you power you filter and heater have you used a big thick gauge extension lead as i'm looking to buy a heater for my pool but been told not to use a extension lead but i don't know how i'm going to get power over for the house to where the pool is situated
How do you order this
just tried our tonight, and its going straight back. its badly designed, the area the grass comes from gets massively clogged up, and even if it kinda makes it to the basket, half of the clippings get lost with the massive space between the basket and the unit.
Sorry to hear that.
Thank you!!!
Hope it was helpful!
@@georgekenny4325 yes very helpful, thank you.
How to fix it if it is not working?
Does it pick up grass as well, if it’s your first cut and there is loads of grass lying around
Not tried it with excess grass, but I would hazard a guess at NO - simply as the prongs are quite thin and would imagine a lot of the grass would pass through.
Thanks
Wait, what???? U ran wire individually to each light????? Why not jst daisy chain it? Parallel????
Couple of reasons.... 1) I had excess NYY-High-tuff cable, so cost wasnt an issue and it's generally inexpensive. 2) The apeture for service is small (even with 1 cable), so daisy-chain would mean 2 connections per light Sure there were better ways to deploy, but this method worked a charm. Thanks for the question certainly SealaxLife
i agree individual feeds plus easier to fault find in future
Not sure about the Gen 1 but the Gen 2 has a passive radiator at the back so probably wouldn’t wall mount it
The amount of leaves in the video is ridiculous. I need to collect leaves on the forest plot!!! This is unusable for such a purpose. In addition, every time the basket is emptied, it is necessary to bend and lean forward. My back wouldn't take it. This is really useless.
Agreed, it's ideal for when you have a light smattering of leaves before the main fall. When leaf fall is heavy, you really need a blower!
At the collecting the leaves, leaves are damaged or not
Looks brilliant. Does is pick up acorns and fir cones??
What type of cabling have you used plz?
NYY-J Cable - 1.5mm
Go to 3mins 50 in the video
Thank you
Is this collector poweres by both wheels or just one?
Please What is the name of that switch use
So did you use Wago’s & then just seal them with silicone?
2. ومن فقط.
Where did u get the heater from what’s the name
It's a sunspring 10kw. You can get them from heatpumps4pools
Please tell me the size
Tu passes la tondeuse, c'est broyé et ça prend moins de place, car ramasser des feuilles entières c'est ramasser beaucoup d'air, tandis que les feuilles broyées on en ramasse 3 fois plus
Oui
@@georgekenny4325 Hello! Would you mind if I feature it on UA-cam with a credit?
@@galyaretka I dont know what that means - but yes, by all means do so :)
*Are you rated to be driven on? I was thinking to put them on the sides of my driveway.*
Hay diferentes diámetros en la lámparas de piso?
Do you know the exact size for the screws that screw the beam to the mount?? I’ve lost mine
I’m looking at buying 8 of these… How are these lights still performing…? Any issues with them or need to replace any of them…?
Good question. 5 of the lights got flooded with water during last years heavy rain. I wouldnt expect them to have flooded, but the actual casing leaked water into the unit. I took them to the supplier and they replaced FOC, but I am concerned come this year if the replacements do the same. So far, they've been good - so it might have a faulty batch. Have a look around, and get a gurantee from your vendor, maybe a trade counter.
Lot of work and detail in this.I have these in smart lighting that are dimmable from a phone app got from lamp and light.They give off great light aswell 👍
Thanks George. Very helpful
Hello what’s it like once the leafs are wet plz
Good review, the fifth time you said “great product” I bought it.
Where. Can I find these lights?
www.aewelectrical.com/products.html This is where I got them from. They're a trade shop, so might not sell direct to consumer. The lights are made by Kensington, so maybe look at who stocks them. Alternatively, Screwfix or similar UK trade outfit should supply.
He’s taped the template upside-down and the unit will be roughly two inches higher than the template portrays.
Well noted Tony!
Should the cabling be swa
Are you asking me or telling me? I guess you COULD use SWA, I think with this tecnique it'd be very difficult to terminate with full SWA on the flex and such a small apeture to work with. On this setup, I had SWA into my box which was adjacent to the patio, and then I used NYY High-Tuff which is strong, but much easier to work with. Hope that helps.
Great video, couple of things ill probably do differently but I love the trick with the waste pipe and will definitely be nicking that!
did you cut the 32mm connections out of your pool to add the 38mm ones?
No. On the Bestway pool that I have, both the IN and OUT ports were already provided and machine cut. Of course, being a plastic pool, you can make the apertures wherever you see fit, but I just stayed with what was provided. Hope that helps!
What did you use to connect the lights to supply i.e wagos,gel box etc... Thanks 👍
I've used Wagos this year as I had an ants nest in one of the chambers which caused excess moisture (prior to that I'd just used loads of electrical tape). The Wagos are larger, but they do just about fit fortunately. Also used a sealant where the lamp meets the patio.
When gake off the cover, how do u change the bulb? Have u to get a new unit?
Hmmmm lots of leaves left over
There are leaves literally falling from the tree during the video...
At least the equipment removes 90 %. I want to see you removing leaves by hand that quick.
What pva or sealant did you use to actually fix the lighting tube into the down tube please?
Sika Sikaflex EBT+ All-Weather Sealant Clear 300ml
se puede escuchar en español
The nunas base needs to be pushed into the seat back by pushing the grey buttons on the side and pushing the base with your knee maybe so it is safe
Ageed - but that DOES take 3 limbs at the same time! Assuming you're able bodied. The comparison is that you can easily dismount most car seats safely without having to be a contiortionist (would help). Thanks for the feedback Giovana!
Appreciated this video
The amount of wires is unnecessary. You can parrell from light bulb to another bulb.
check adac crash test nuna is a big fail dont buy them
Do you have sound coming out of the beam when connected to ARC output you showed? I have LG TV with ARC, similar year old like your TV, and yet had to connect to optical interface of the TV, hdmi ARC was nor sending sound out. Thank you.
Did not need optical at all chap. ARC is all that was required. My tele shown on the video is an old 2015 Samsung model and works a charm to this day with just the ARC interface. Good luck
Like my shoulder leaf vac
Have you considered pairing your Aeroccino to one of the Sonos Play 1's as the other surround speaker? I believe Sonos is working with Nespresso as a partner and I've found their products work really well together. 😏
That Chime part! So true and very annoying especially when your in a call/meeting. You literally miss long seconds of communication.
Dont know why there is thumbs down this answered all the questions I had and in a short to the point video
He used the word 'conduit'
ive had two jabra evolve 65 both have snapped at the ear cup on the microphone side, placing it on a desk should not break these but it do
That's unfortunate to hear about. Definitely take a look at the Evolve2 65 and the brand new Poly Voyager Focus 2 UC. Durability issues should be improved based on our initial tests.
Where did you buy your mount please?
It came with the sonos.
@@georgekenny4325 I bought Sonos from Costco, but have not gotten the mount 😮
Bad battery