Desert Rat Garage
Desert Rat Garage
  • 16
  • 7 246
I built this gravel pad on a huge budget. Only $33
I built this gravel pad on a huge budget. Only $33
Переглядів: 42

Відео

Wood cart (made from pallets)
Переглядів 909 місяців тому
Wood cart (made from pallets)
Looking into the problem with the CT90
Переглядів 5311 місяців тому
Looking into the problem with the CT90
CT90 pt:3 I hate wiring. (Only 2 wires)
Переглядів 1,2 тис.Рік тому
CT90 pt:3 I hate wiring. (Only 2 wires)
Trying something out. Also I made a shade canopy out of some pallet wood.
Переглядів 23Рік тому
Trying something out. Also I made a shade canopy out of some pallet wood.
CT90 pt:2 (engine rebuild)
Переглядів 151Рік тому
CT90 pt:2 (engine rebuild)
Fixing up my CT90
Переглядів 78Рік тому
Fixing up my CT90

КОМЕНТАРІ

  • @lunger2006
    @lunger2006 19 днів тому

    That spacer goes between the intake and the carb, NOT between intake and head.

  • @ryanmundell3504
    @ryanmundell3504 3 місяці тому

    Grate vid do you have any recommendations for a easy install

    • @desertratgarage9480
      @desertratgarage9480 3 місяці тому

      I didn’t really install this it came stock like this from the dealership.

    • @desertratgarage9480
      @desertratgarage9480 3 місяці тому

      If your trying to install some tweeters then I would think you’ll need to run a few wires from your door speakers up the A pillars and then in the roof but need to take the head board off in order to install it.

  • @user-pg6jl7jw7s
    @user-pg6jl7jw7s 4 місяці тому

    If your battery keeps going dead on you, it's because you don't have the rectifier hooked up.

    • @desertratgarage9480
      @desertratgarage9480 4 місяці тому

      Yes and I know that but I’ve also mentioned in the video in the same clip where I said “im not going to be running the rectifier because my stator is bad and doesn’t produce any electricity or charge to the battery”. It’s closer to the end of the after I’ve shown the bike running. Also thank for commenting your are the 2nd who has commented overall and really really do appreciate it.

  • @prestonholland2280
    @prestonholland2280 5 місяців тому

    spitting oil out the exaust was caused by your honeing job

    • @desertratgarage9480
      @desertratgarage9480 5 місяців тому

      Thank you for being the first to comment I appreciate it but if you also watch the other video I made about looking further into the engine I have mentioned before many times that theirs really bad pitting all over the cylinder walls from it rusting and sitting and their for the oil was bypassing through those gaps. I didn’t hone it that deep or that wide open. Also the pallets were free from picking up elsewhere, I wasn’t meaning that it’ll free up space.

  • @prestonholland2280
    @prestonholland2280 5 місяців тому

    the pallets wernt free you lost all your space