Відео

Arent you supposed to torque from the nut and not the head?

Great team!

The best thing about this is how you’ve involved your daughter. Good dad.

I wash it in varsol and stir the varsol well with a neodium magnet on forceps, making sure to run the magnets against the bottom. It seems to get everything ferrous that was in the filter. Usually a bit of very fine ferrous particles like a microscopic fuzz just barely visible on the magnet, or a kind of ferrous mud. I then agitate the varsol and pour it into a black plastic tray, let it settle for a while, then drain off the varsol. Non ferrous particles show up well against the black plastic. Like panning for gold. I usually get random micro speckles.

Is it raining?

I can’t understand how you do it so easily. I attached two Lycoming to my RV8´s . Holes never aligned, struggle to insert bolts and chose the right order .

I like the music 👌🏻🙂

Thank you very much. This was very helpful

Even the Garmin 2.5” of strip length is about the most I would want. Every inch those wires extend outside of the shield is more “antenna” to pick up noise. Ideally, you want the shield of the cable to extend into the metal back shell on the connector.

Great job guys it’s always nice to have a helper

You guys rock!

What timing.... I am going to replace my old non-touch G3X small screens with a G3X large touch and G5 this Fall in my RV7A. Great quality video!

Well done! She will never forget these wonderful moments with you. Thanks for sharing with us.

I love your video and would love to watch more of these aircraft videos!! A little about me, I am currently in A&P school for my A&P license I still have a year left but I want to be ready to take my orals and practical's and study for them. I am very determine and passionate about aviation. That being said do you guys have any advice for me for the future to come?

Really cool that she helps you work on it. Hoping my son helps when we start on ours.

Thanks for the fun and instructive videos!!

You're very lucky to work in an area on the aircraft with room like that for the clamps and the driver. If you are in a tight spot, I would recommend using safety wire to hold them together while threading the screw into the holes. Having about a 3 inch loop already clamped in the pliers, then putting it over the clamp and twisting. Hope it helps.

Great job. Hanging my engine this week on my RV-14A and you have shown me the way! Thanks.

Where did you purchase the manifold pressure switch block on your firewall?

Very well narrated and very timely since I am at exactly this spot on my RV 7 A project ,I just ordered my Garmin hardware yesterday,, Love to see how are you build the shelf , and radio racks to carry all the ancillary boxes and remote radios etc.

I just got my g3x garmin system. I am having problems finding the wiring diagrams for what pin goes where and what wire size. Started mounting the GMU 11 Magnetometer in the wing. Any hints on were to start? Thanks great video.

Awesome! Way to go! Job well done 👍

Spaghetti mess 😂

Awesome!

No sweat 😅

And that's a good thing!

Way to go crew!!

Good job, Anna!

Nice job!

Awesome job Anna!