Відео

Thanks, I will do it soon

@@nellyjoungblout-tl8ob The component roll can be replaced while the feeder is on the machine, but removing it will be faster and more spacious.

ua-cam.com/video/iymczQVs5eY/v-deo.html

yes, there will be

It is made from CNC aluminum so it is highly accurate

No, it is an industrial CNC machine, manufactured by Dongbu

42$ for AF8

There will be continuous operation video to check the stability

1- Number of components is about 150. Actual speed is 1400-1600cph. 2- Repeatability accuracy +-0.02mm

@@AFARCO-PnP For #1, 150 placements / 7 minutes works out to 1286 / min. Your quoted range seems reasonable. (Also, I didn't remove the strange stalled time at the end.) Thanks!

0402 is very simple. I will upload videos soon or you can search for old videos on the channel

Our machine is running on OpenPnP software, it has many things that are not optimized to achieve high speed. Unlike machines made by Chinese manufacturers

@@AFARCO-PnP In the end, there are technical limitations no matter how well the hardware is made due to the absence of software. If so, I think it is necessary to make the machine smaller and simpler. It would be better if you reduce the cost by reducing the feeder base to one and pay attention to precision focusing on heterogeneous chips that do not have a problem with speed rather than small chips. I also use some mini PNPs and the high speed one is made in China with 4 heads. This is when taking a chip at high speed and the other machine is for release only, I need this good combination because this is not a speed issue and precision comes first. Additionally the question is, does the camera calibrate both angles and coordinates when picking up the chip? Or only the angle is calibrated?

Please wait for me. I will upload video soon

Thank you

Hello. You can see more videos on my YTB channel, I have fully posted them

Please contact me: contact.afarco@gmail.com

Thank you for accompanying me on the Electric Feeder project, even though there was a delay, everything was perfect

Thank you, 2024 will have more updates and more discounts

Thank you. I will demonstrate in Part 2

Thank you!

аналогично. сейчас попробовал цифровые сервы заказал на замену

You should perform nozzle calibration, nothing is absolutely accurate

Are you confused? The X axis uses 2 Hiwin MGN12 linear rails

@@AFARCO-PnP exactly! and do you know why those hiwin mgn12 have holes along whole length not only at the ends? because they were not designed to self support. they need to be not even screwed, but precisely torqued to specs on flat support to retain accuracy. these ones unsupported must bend, flex and twist easily within 1/10 of a mm on high load and chew itself up in a year... while properly installed and maintained linear rail can deviate from ideal about a micron and easily outlive single person...

@@dodman0907153500. The small load of the head at the velocity , acceleration, and jerk of the x system probably isn’t enough to make it fail in its lifetime but good job pointing out the potential flaw. I’m going to purchase one as soon as Mr. PNP qoutes me the unit with all yamaha feeders

Smoothie

I'm from Viet Nam. My machine can be delivered over sea

Hi. I use pump and vaccum valve on off. Pump turn on before valve on

Hi. My email: contact.afarco@gmail.com Facebook: facebook.com/afarcovietnam

I don't see a message from you. You can contact me again

@@AFARCO-PnP Thanks, I have send you a new email with my gmail account.