- 8
- 44 908
Cutthat
Приєднався 1 жов 2011
Real Samurai Customer Review
Watch Sean from Modern Country Living unpack and set up his new Sabre Samurai Cutter!
Переглядів: 443
Відео
This Sickle Bar Cutter Mounts To Any Front End Loader
Переглядів 271Місяць тому
Samurai is the most versatile sickle bar cutter on the market.
Tired Of Using A Handheld Trimmer? Try This
Переглядів 956Місяць тому
Our hydraulic powered sickle bar mower will allow you to clear acerage without leaving the seat of the tractor.
You've never seen a sickle bar like this before...
Переглядів 2508 місяців тому
As tractor owners we grew tired of trimming brush by hand so now we cut acerage without leaving the seat of the tractor.
Sabre Samurai Hydraulic Trimmer on JD 1025R
Переглядів 8 тис.Рік тому
Sabre Samurai Hydraulic Trimmer on JD 1025R
Sabre Samurai Hydraulic Trimmer Tractor Mounting
Переглядів 31 тис.Рік тому
How to attach the Sabre Samurai to the loader bucket using the Deluxe Bracket Mount.
Sabre Samurai Deluxe Bracket Unboxing & Assembly
Переглядів 3,7 тис.Рік тому
Sabre Samurai Deluxe Bracket unboxing and assembly instructions.
I like this been looking for something like.this for.a while. They should send some out to a few you tubers to gain traction in the market
like your video
I own one and it is not very impressive. I took my concerns to the customer service department and they proceed to tell me it was supposed to have a 1/8 gap between some of the blades because they warp in the heat treating process. Hmm I peened them straight and shimmed the sickle and knife. Then it cut much better.
mine is the same way the whole thing bent I"ve fooled with it a bit it doesnt cut weeds very well but is ok on twiggy stuff.
@@anthonymorrison2167 Did you contact Cutthat and complain?
forgot to ask how did it hold up and do you have a picture of how you shimmed it?
I'd love to demo one of these units on our channel for you.
I wouldn't bother. I own one and it is not very impressive. I took my concerns to the customer service department and they proceed to tell me it was supposed to have a 1/8 gap between some of the blades because they warp in the heat treating process. Hmm I peened them straight and shimmed the sickle and knife. Then it cut much better.
How do you have it plumed?
You can plumb the Samurai a few ways...1) you can use a 3rd function valve if you have one or 2) use the tilt remotes from the bucket. (our website has further information on the Installation tab on the Sabre Samurai product page.