Відео

@@johncarlos3120 adjust the idle on the carb or if it has a lot of hours it may need the valves adjusted

@@WiseChoicePowersportsLLC ok I’ll try that but it’s literally brand new

I’m not sure what you’re referring to?

If brackets are bending then you don’t have axle bolts loose to adjust the chain and probably why you’re saying axle slipping or chain coming off ?? Setup has been used on many brands for decades

They don’t have a screw head on factory ones

We are open Monday-Friday 9-6, Saturday 10-3. 419-443-8194. Thank you !

It runs wide open

Just the yellow one will be fine

Not sure depending how old the gas is I would start with that and if it’s been sitting, it could be a carburetor as well

@@WiseChoicePowersportsLLC should i clean the carburator

Clean or replace

I ordered a new one

It’s normal just let go and don’t plug off

Call your local dealership

21 what model?

Yes bike I have doesn't have bolts underneath to adjust

A dirtbike

@WiseChoicePowersportsLLC sorry it's a quad jackal 200 . With no chain bolt adjustment I can send pic if I can add it here

@@enrique19791215 it’s on a cam just loosen it up and you’ll go on the drives sprocket behind it and adjust it

A lot of other makes and models do use a switch just like it for blinkers, yes. Are you having an issue?

For starting?

If it has a key yes

Just bring it to hardware store and match up to get a lock nut, worse come to worst try lock tight.

I’m sorry don’t use the battery tenders. Easiest way is to put a heater on or close to the right side engine side case. Don’t want to melt any plastic so need to pay attention to how close it would be needed. By putting a small heater or salamander on the right engine side case it will warm up the engine oil and turn the motor over easier to start. The batteries that they put in all of these units are very small with very little cold cranking amps.

@@WiseChoicePowersportsLLC I understand to a point but I bought them brand new and let them sit in my garage for 2 winters. Now they just seem dead

@@islord999 so you have let them sit for two years without running them? Sorry 2 winters only? If you’re letting them sit that long or not letting them ride through the winter then you need to winterize the four wheeler as far as draining fuel out of the carburetor and I would out of the gas tank or run non-ethanol fuel, but I still would drain the carburetor. At that point battery tenders would be needed. It’s very simple but positive on positive and negative or negative. I’m sure it has directions on packaging as well.

@@WiseChoicePowersportsLLC thank you! You’re the man

@@islord999 Thank you!!

No

How do we change the cdi box and how many pins is it?

@@chrisstokes9627 Find it unplug it and check to see how many pins I’m not sure off hand

Size and shifting the td is a bit smaller and semi and the tt have bigger wheels and is manual with a clutch

I’m not sure I think I would look over the unit see if anything may be loose or pinched fuel lines.

Brake levers applied?

@Wise Choice Powersports LLC yes while I go to start the atv. I attempted to start it last season but it was low on gas so the engine never turned over fully and I kind of forgot about it. So I'm wondering if it's the starter maybe but not sure.

@@bradykline506 if the brake light comes on and you’re saying the battery is good. I would take a 12 V test light ground it and pull the starter wire back where it connects to the engine and see when you push the starter button if the starter has power to it.

​@Wise Choice Powersports LLC so I figured a way to start the atv with screwdriver to the selinoid.. so that's good. That's the only way it will start through. Any ideas?

Replace solinoid

Check starter button or switch

@@WiseChoicePowersportsLLC the relay clicks constantly as we hit the starter button/switch so I think the starter switch it ok. It just wont crank over. During the frozen months, we did have a quite a issue with the relay freezing up because the tires, splash water directly on it but as soon as we would thaw it out with the heat gun it will turn over immediately temperatures are way above freezing now, so that’s not the issue, but it won’t crank over. It just clicks I’ve tapped on the relay and tapped on the starter as we’re hitting the start button.

Na fr homie didn’t even touch the bolts 😂😂😂

Yes but, mainly because units setting and not draining fuel out of carb or running cheap fuel or not running non ethanol

Can message on Facebook Wise Choice Powersports

@Wise Choice Powersports LLC thank you I will message you tomorrow because it’s dark outside

Yes but have to block off intake nipple

Glad it was helpful!

This is so helpful

@@Fweddy2fye Thank you!

Videos on that kind of stuff is different for every dealership. Read manual and I believe I already spoke with u. Thank you

We will also be coming out with more videos as well. We just started this right before Christmas.

I accidentally commented separately, check out the comment I pinned! Thank you!

Did you guys get one