Відео

Hi, I need to replace the bottom plate seal on my Tecumseh Model 850 air conditioning compressor, but I cant find the seal. Do you know where I can find one??? Thanks!

It is a bad idea to use PAG or POE (ester) oil for compressor assembly, seals, o-rings, etc. These oils are very hygroscopic, and they will inevitably pick up moisture and introduce it into the system. It will also invite rust/corrosion on the adjacent ferrous surfaces that are exposed to air. Your best bet is to get a quart of AC/refrigeration mineral oil and use that. Viscosity doesn't matter since you're only using it to lube seals and assembly parts. Mineral oil is chemically compatible with R-134a, it just doesn't mix with it. It is also chemically compatible with PAG and POE oils. Because the amount introduced into the system is so small, it's lack of miscibility isn't an issue. Also, minimize the amount of time the compressor is open with the oily internals exposed to air. If you have a nitrogen cylinder, it is a good idea to sweep and purge any air out of the compressor once the work is done. It also goes without saying that any oil in the compressor should be dumped and replaced with fresh oil just prior to evacuation. If the system isn't going to be charged for a while, evacuation should still be done, followed by a low pressure holding charge of nitrogen or R-134a. 5-10 psi is plenty. I will forgo my rant on why these systems should be kept on R-12 rather than converted to 134a.

I am truly sorry this happened. We'd like to assist you with this matter. Please email us the details to help@ups.com. ^MH

where you buy this special tool ?

Thanks for the video. The bearing on mine blew out far away from home. The pulley itself it self is not available so I bought the whole unit. With the help of this video I robbed the pulley from the new one and got the car back on the road in just a few hours. Yes it was expensive, 600 dollars but this could have been way more extensive and much longer down time.

Thanks ..I have problem from climacompresor .. And this video is BIG help for me ...

thanks.....

Is it common to replace these pulleys? Do the bearings make noise or do the rubber dampers perish?

That's the info I've been trying to find! Allow me 2 questions though: Is the procedure the same for all 7SEU? Mine I believe is a 7SEU17C (Denso 471-1559). Is removing the 7mm bolt the same procedure? Thanks!

when to replace the pulley?

Hi, Great video! will this process work with the compressor mounted to the car?

Thanks!

Thanks, this was a huge help!

very informative