Відео

Finally, I got around to getting things ready for the new parts

just a quick update on my NV4500 rebuild. I'm sorry progress has been slow lately. too many projects and life events at once. link for the bearing / seal kit: www.summitracing.com/parts/SPZ-75476

just a quick overview of this bike I've been working on. link for the pulleys used: www.oreillyauto.com/detail/c/powergrip/gates-powergrip-timing-belt-pulley/gatu/t42015?q=Gates T42015&pos=0

Finally got around to tearing down my NV4500. Now to scrub and clean for 12hrs to have the cases ready to shine up.

I could not find the GM special socket for the NV4500 5th gear nut anywhere. so I made my own.

I didn't think about getting the camera out until I had already pulled 5th gear off but it's all very simple so far I'm sure most could figure it out going in blind. there is a special tool that is needed. I will make a short clip of that soon.

Really this is a general state of the whole garage update. primarily focused on the new workbench build and an update on how the engine has come along.

all in all, the adapter plate kit from kwik performance works perfectly fine. I'm the one mismatching parts like Frankenstein kwik performance adapter plate kit: www.kwikperf.com/k10473.html

figured I show the little progress that has been made since the carb was mounted. hopefully, I can start getting parts in soon after the holidays have run their course

In this video I modify the Spectre Universal Carburetor Adapter from AutoZone. I did this simply to have my carb mounted by the end of this weekend, any proper adapter was not local, out of stock and cost more than its worth. A little bit of designing in Fusion 360 and 3D Printing with some all thread and drilling made an easy project. links to the 3D printed parts below. Materials: Blue RTV, 5...

In this video I'm briefly showing just how simple it is to cut BBC valve guides to fit narrow valve stem seals to run dual springs that are stock diameter. links to products in this video: Valve Guide Cutting Tool www.summitracing.com/parts/CCA-4715 Arbor/Pilots 4734 www.summitracing.com/parts/CCA-4734 Valve Seals www.summitracing.com/parts/CCA-514-16

this is a reshoot of the first camshaft degree video as I got a tripod and wireless mic for hopefully better production equality videos and clearer explanations

in this video I degree a gen VI roller cam in a Mark IV 454 BBC, using a comp cams adjustable timing set. I need a tripod or something to get better shots. it in the works. sorry for the non linear explanation on the process but hopefully this helps someone. here's the link for the clay smith cams video that I learned from as well: ua-cam.com/video/57gfBu8uc6k/v-deo.html my dog is fine now, not...

1993 Chevy K1500 454 big block build progress update April 2 2023

1993 Chevy k1500 4x4 NV4500 Transmission removal

1993 Chevy k1500 front axle / differential removal

engine removal and tear down

MotoVlog2 on the 2nd

first moto vlog

Fork seal replacement on 1986 Kawasaki Vulcan

86 Kawasaki Vulcan 750 turn signal fix

first ride with the new cam (im so sorry) part 2

first ride with the new cam (im so sorry)

77 sun bug floor pans getting preped

77 beetle Chasis prep

Body investigation

Under side Chasis wire wheeled

1977 Beetle Chasis is getting prepped

Both pans are ready, - 77 vw beetle