Відео

Thank you I needed to know the original order because of a other guys fix

Awesome! Thank you!!! I tried pulling a bunch of crap around back seat and couldnt find the dam top cap 😂

Did the injectors fix the problem?

That's one heck of a job. I started to work on a 2009 today with random misfire on 1 and 3. Spark plug on 1 and 3 were destroyed... changed all spark plugs, still wouldn't start. put in New coils and then it started. Still has a code for 1 and 3. So now I have to get the injectors out.

Hi I don’t know that much about Hyundai Vvt. Check the vvt filter check all the hole for vvt make sure the oil go to the vvt . Check the Camshaft vvt make after that all good go check the power from vvt go to the ECU

useless video. you wasted the time, and value time to explain other things in the video. WHY YOU DON'T USE THE MIND?

Elantra 2007 Hello sir. I have a question. Do you know how the the OCV behaves on start up? I'm currently troubleshooting a persistent P0016 and have treble checked base timing which is perfect. I've replaced the Cam phaser on the end of exhaust cam. New Cam sensor also. Can sensor is good also but not replaced; pcm sees if it is left unplugged during startup and engine revs are affected accordingly. So, i removed the new ocv, plugged the hole in the valve tray with a rag and attempted a startup with ocv in the loom but out of the engine. I noted that it pulses during startup. Surely it should just retard during startup, and begin to advance around 1500rpm? Also.... can you please tell me ( if you know ) the amount of chain links between the mark on the vvt phaser and the inlet cam. This seems like a conundrum for all! Autodata says full link on timing mark on phaser, 5 full links and the next full link lines up with Mark on inlet cam. Hyundai Service manual shows 4 full links between. UA-cam diy mechanics have shown Seven! Links between. Out of some desperation i moved the inlet cam one tooth toward the Exhaust cam to have only Four links between. I had no P0016 on start and drive but the vehicle would not pull at all below 1500rpm... it just splutters! So you have any pictures of your cam phaser set up ?????? I apologize for long message! Best regards, Eddie

What about the arrow on one edge of the filter? You didn't mention it and neither did you mention that some brands have arrows that indicate which side goes up and other brands indicate air flow direction, which is down.