Відео

Boat7, glueing the cover and the lid.

Boat6, releasing prints from glass plate

Boat3

Boat5

Boat4

Boat2

Boat1

3D printed F1 rc boat, continued.

The parts, even though corrected, see previous video, are not really user friendly. They are just the hull sliced in sections, no means to make it whole. So I am thinking up solutions as I go.

Thingiverse F1 boat remix / file fix.

3D printer losing steps bigtime.

Wiebel derailleur

Na vier keer gecontroleerd vallen had ik de smaak te pakken. Het gaat nog voorzichtig en schakelen moet even wennen, maar het lukt! Camerawerk van mijn zoon, waarvoor dank.

It is not uncommon, to say the least, for some idiot to have tried to remove these screws without the proper T25 screw bit. Here's how I tackle that problem when all else fails. I don't like grinding a slot into them, as I have flying metal sparks anywhere near an open engine. I replaced the screws with M5x10 T25 drive ones from stainless steel 316, also known as A4. These are quite tough.

First drive with the turbo on the car.

3DSet Model 10 Bamboo 1

Messy first layer on corners.

Final result CR-6 bed probing on my printer

Lexan RC body copy part 4

Lexan RC body copy part 3

Lexan RC body copy part 2

Lexan RC body copy part 1

CR-6 like weigh cell hotend bed probe Part 2

CR-6 like weigh cell hotend bed probe Part 1

Printing with Super Slicer

Major goof in ECU PCB

MX-5 NB harvesting a door connector from the breaker yard

MX-5 1.8 VVT bad cold start on Speeduino

MX-5 soft top inner corners damaged.