Відео

great guide , i have my sliding table running good with a criss cross pattern ,, the side fence is ripping material with no burning marks , the issue i have now is over the length of the side fence "1 meter long " the material is creeping off .7 of a mm away from the fence .when i try to minimise this i am getting the binding on the side fence or the burning marks on the sliding table side.

Still coming in handy mate ill tell you that

This didn’t work for me apon measuring diagnal even tho same thickness

Great to see that... I made it too. Plans from Stodoys helped me a lot :)

The becker maintenance manual says to grease the bearings every 3000 hours. Is this incorrect?

Hi Mal... are you able to get parts for a mid 80’s Griggio SC 3200 I am restoring?

Production Supervisor: What's the status on the edgebander? Maintenance Tech: We don't have a back up ready so it's gonna take a while to clean it and get it up working! Production Manager: Great.😭🤔😭

You consider your self a professional? Where is the blade safety ? Why the heck will you remove it

what should I do when as I pump the high temp grease and it oozes out as if the grease is not entering...I assume that the glue pot has not been taken care off ..so the pot is filled with dry grease? or some one put the wrong grease in? I'm thinking that the glue roller will need to be taken out and refurbished?

Hi do you do any work with altendorf saws I have a wa80 I keep getting a e7 error when I tilt the blade and when I lower or raise the blade

Do you have a video on how go adjust the glue scrapping blades...bottom blade leaves 2mm of tape...can't get it right...

Thank you very much ,sir

GLEITMO 591 grease up to 260 Celsius

A crystal clear explanation of maintenance, nicely done. Greetings from Becker in the Netherlands.

what about how to clean the glue spreader wheel??

why do you need a slight gap at the front