- 9
- 23 363
Tadej Kastelec
Приєднався 13 вер 2014
Відео
edc pump - cc215 disabled
Переглядів 7786 років тому
cc215 chip disabled. ecu still tries to control the rack without position feedback.
edc pump - shorting ring on hdk coil
Переглядів 1,2 тис.6 років тому
Simulating shorting ring on the rack with a shorted wire loop. Scope connected to analog output of cc215 chip. Voltage corresponds to shorting ring position.
edc pump analog output
Переглядів 8436 років тому
Edc pump connected to original ecu. Probing analog output pin on cc215 hdk coil driver chip and manually moving rack. Dc output of the chip directly corresponds to rack position.
edc pump connected to original ecu
Переглядів 6926 років тому
Ecu powered on. No immobilizer signal so it goes straight into cutoff mode. But checks rack operation nonetheless. Very fast and percise control with no overshoot.
Jaguar XJ6 XJ40 3.6 manual 0-100km/h acceleration
Переглядів 16 тис.6 років тому
1987Jaguar XJ6 XJ40 Sovereign 3.6 litre original 5-speed manual getrag gearbox. 165kW/221hp original non catalyst, no o2 sensor engine. LUCAS POWER!!!
Что за ЭБУ???
any more infos?
May I know difference between XJ6 and XJ40?
So technically they can mean the same thing. The xj6 is the model as in an “XJ” body with a “inline 6” engine. The XJ40 is referring to the specific generation of XJ6 that ran 1986-1994. The generations after that had different generation numbers like x300, x308, x351, that marked the differences in engine configurations amongst other changes
@@red_haired_ken Exactly and an XJ series 1,2,3, XJ40 and X300 are all called either XJ6 (L6) or XJ12 with a V12. X308 is XJ8 with V8 petrol only,, X350/X358 is called either XJ6 with a V6 diesel or petrol or XJ8 with petrol V8.
Hello where are you from my friend?
Hello. Can you help me I’ve got om606 and when decelerating or when hot engine at idle I’ve got rough erratic idle… probably by the fuel rack…
And about a gallon of petrol... 😆 Love those old xj's my favourite though are the x300's even the more modern x350's look tasty and you can pick one up for peanuts. The air pumps can pack up on them but replacements aren't too expensive.
Hey. Could you give some more info regarding this control? how do you do it?
Hello, how do I cancel the protection?
Hello,how i can control this regulator, do you have a wiring diagram?
Beautiful
Where are you from?
Do you have the schematic for the pins? I'm trying to troubleshoot edc the goes to full fuel on startup.
Hi mate, can you explain me how to adjust rack position sensor? When i remove the cap at the end, i see a screw behind and a castle nut. I have to unscrew the screw and afterwards i can adjust with the castle nut? greets
Why do you need to adjust the sensor? Do you have bigger elements fitted? I have not tried to knock the cap out yet, so I don't know how the screw looks.
Hello, I have a fault with that pump, I don't know if it is the cable or the solenoid in the video, has something similar happened to you? thank you
What exhaust mods do you have on it
Exhaust had a really big crack right after the first Y pipe. It's since been welded back up and is very quiet.