Відео

I use kerf offsets for certain things, but due to variations in materials, lasers, and cut complexity, I still like to do test pieces in different materials to make sure that things are fitting correctly.

@@artfromearth3886 Okay, you're right.

Start making boxes to organize some of your other stuff, and you might have more time to play with it.

It depends on the humidity where you are; if it's hot and dry, it will be dry by the next day on a small repair like this one.

It sounds like you need to make sure that your Z axis is moving in a positive direction; the "End Z" number should be higher than the "Start Z" number. I'm not sure what you mean by 17-material thickness; who is your manufacturer?

@@artfromearth3886 my manufacturer is Gweike. They say my focus is 17mm - The thickness of material example. 17 -3= focus distance would be 14mm.

@@artfromearth3886 My manufacturer is gweike cloud. The way they say to calculate the focus is the subtract the thickness of the material being used from 17mm and the number you get is what would be input for the distance.

If you are using the LightBurn focus test, I would try starting at 17mm, and then moving down 1mm in steps to the thickness of your material (4mm). Then run the test again, and move up in 1mm steps- see what happens.

Hi Tina, I'm using a spray called Bakers Joy; it has flour in it, and is less runny and oily than other things that I have tried. It cleans up easily, and probably works well for baking too.

Hi Andy, the 6 inch tiles end up 3/8" thick, after drying and firing shrinkage.

@@artfromearth3886 thanks, can you tell me the thickness before fireing?

About 7/16".

@@artfromearth3886 Thank you Rex