Відео

This shows some of the wiring that wasn't clear in the original video from about 3 years ago. The touchscreen stereo is a low cost unit bought on Ebay . The stereo has worked very well in my car for several years now. I've had a few questions about some of the wiring I did. This should show in better detail my installation. Look up 2007-2023 Dodge Chrysler aftermarket stereo install antenna ada...

I set the odometer to 999,999 miles to fake a 1 million mile rollover just for fun.

This car was at the 50th Turkey Rod Run at the Daytona Speedway. I briefly spoke with the owner and he said it has a 383 stroker under the hood and a GN 8-1/2' axle in the back. The car was super clean and looked great.

This is a few video highlights of my recent flight to Italy. This was my first flight on a Boeing 787. I was happy to have a window seat where I can at least a little view.

While I was walking to Vatican City a woman slipped and fell off a wall. It looked like she hit pretty hard but she was immediately helped up and it looked like she was ok.

I Just went on a tour at Saint Peters Basilica in the Vatican City in Rome. I bought a ticket to go on the roof. I rode an elevator to the rooftop then went up some stairs to reach to top of the dome. The stairs are sometimes around a pole sometimes straight and some are curved. At one point it was very narrow. You can see this in the video. There was so much to see, the experience was amazing.

A few seconds of video watching the engine running in my car.

This is how the backlighting and needle colors can easily be changed on the Dakota Digital HDX gauges using a phone app. The phone app isn't required but I think its easier than using the buttons on the screens.

This tool will magnetize a screwdriver is seconds and will unmagnetize it just as fast. The magnetizer tool I used is a Craftsman Magnetizer/Demagnetizer #945021.

There is a small bird nest in my Mango tree. The parents of the bird are close by but I was able to see the hungry baby bird in the nest.

This is a compression test I did on my 2012 Ford Fusion. I found a significant valve cover oil leak that I'll have to fix. I think the compression is really good for a 4 cylinder car with 218,000 miles on it. A compression test can easily be done in under an hour on this car even if you take your time. The tools I used were a 1/4" drive ratchet and hand driver 8mm 1/4" drive deep well socket 3/...

I found some damaged wires on a coil pack wire harness. This video shows how I repaired the damaged harness. My car ran perfect when I found the damage and still runs perfect after my repair. Tools used were a 1/4" drive ratchet and extensions 1/4" drive deep well 8mm socket 1/4" hand driver Electric Soldering Gun and electrical solder Small heat shrink tubing micro torch (a match or heat gun w...

This is how I removed a pair of electric cooling fans from a junk Chrysler at the junkyard.

New Wheel Bearings For Blazer Spindle Swap Monte Carlo

Cadillac Ranch

Spark Plug Glass Breaker

Wheel Fell Off

Ice Cream Truck In March

HighBeams

Install A Ford Fusion Wing

Connect LS Swap Cruise Control

Dakota Digital Cruise Control Light Connection

Driving slow with a severe vibration in the middle lane

LS Swap AC Compressor Mockup Fit

Quick SS Monte Burnout

compass wheel bearing fix

Harley Test Ride 2022

Mini Spool Burnout

Jeep Compass Inverter Install Part 3