Phil Okeefe
Phil Okeefe
  • 20
  • 17 534
First glider solo landing
Short vid of my first glider solo and landing, filmed by my instructor and son Alex.
Переглядів: 66

Відео

Slingsby T21 fun
Переглядів 64Рік тому
Washing her after a days flying. Disclaimer: Please note the 'wash' was flown by two very expienced highly quilified senior instructors (haha!) who got absolutely soaked! So don't attempt this without help and wear a s'wester and take an umbrella. No, hang on the umbrella wont work...oh you're grown ups, I'll leave it to you.
Wren gas turbine start and run 160k rpm
Переглядів 472 роки тому
Finally got her started and running up to 160,000 rpm! A sweet day after months of trials. She's off the bench now and out of the workshop and we are fitting her into a Retrojet airframe for flight testing in the new year
Air Ambulance small field departure
Переглядів 2832 роки тому
Essex Air Ambulance departure from a small field, tall oak trees on three sides and houses on the fourth. A nice clean lift off, clearance turn and back track with a smooth departure on the top of the avoid curve.
Air Ambulance small field landing
Переглядів 9 тис.3 роки тому
Essex Air Ambulance approach and landing in a small field. Apologies for the poor quality, it all happened so fast I just grabbed the nearest camera to hand!
Bagpipe serenade
Переглядів 263 роки тому
A lovely bagpipe serenade by Denise, accompanied by Katie (RN) on the drum.
Wren 54 gas turbine successful start!
Переглядів 2703 роки тому
Success! The fuel and lube lines were the wrong way round! Nice start, smooth pick up and for the first time she spooled up to a smooth 165000 rpm and back to 35000 rpm idle.
Wren 54 turbine FIRE IN THE HOLE!
Переглядів 1803 роки тому
Another start attempt after quite some time spent on rebuilding - and learning about - this engine. As you can see it did self sustain but was flamey and full throttle only produced a somewhat frightening earth shaking 70,000 rpm. After some brainstorming we deduced that the fuel and lubricant inputs to the engine were transposed and will fix that for the next attempt. That explains the flames,...
Aeronaut LT200 airbrake and aileron set up
Переглядів 1,3 тис.3 роки тому
This shows my revised airbrake servo install, horn modification. See also the aileron servo install and proposed pushrod geometry. Your thoughts....
Aeronaut LT200 flex airbrakes
Переглядів 1 тис.3 роки тому
Airbrake details. The control horn for the airbrakes supplied with the kit doesn't really work. They are at 90 degrees to the hing line. I replaced these with my own design (40 degree rake toward the trailing edge) and may post a video if required. The cheap 'toy' aileron servos have been descarded and I have quality 'flat' aileron servos to go in.Again, let me know if you want to see that
Aero naut LT200 build
Переглядів 2,1 тис.3 роки тому
Lovely kit, lots of work. Not for the novice! The airbrakes are now finally sorted, the cheap aileron servos have now been replaced by quality 'flat' aileron servos
Glens models CAP232 radio/RX installation
Переглядів 533 роки тому
This is an update of the CAPs electronic refit to bring the CofG in limits without ballast.
OS FP35 in DB Mascot resurrection!
Переглядів 1484 роки тому
More lock down lunacy. In 1984 I finally had enough money to fulfil my dream - four channel proportional rc model flying. Futaba 35mhxz, OS 35 and Dave Boddingtons Mascot kit. Massive fun learning to fly at the local club. Here we are decades later, the FP35 is my original (started second flick after a 30 year lay up), the Mascot is a bit of a president Lincoln's axe and is in the hanger being ...
Chris Foss Wot4 Classic 4Stroke perfection
Переглядів 4474 роки тому
Running the OS 48 Surpass in the Wot4 after her maiden on the 4th June. New glow plug (OS), 12x6 prop and mixture set. Looking forward to the next flight!
Mick Reeves Lightning...and some other classics
Переглядів 4614 роки тому
Four of us got together, social distancing observed, for a model fly. All of us had a model that had been waiting be test flown (since March). We flew them all successfully. When I viewed this clip I saw that by chance we had five classic models all with the whole range of RC model power plants. Can you name the models? Can you guess the engines? No prizes, just a bit of fun. Some clues; Mick R...
Chris Foss Wot4 Classic build
Переглядів 8754 роки тому
Chris Foss Wot4 Classic build
OS48 Surpass starting and running
Переглядів 914 роки тому
OS48 Surpass starting and running
Glens Models CAP232 Zenoah engine
Переглядів 2384 роки тому
Glens Models CAP232 Zenoah engine
Glens Models CAP 232 Zenoah 45cc start
Переглядів 7084 роки тому
Glens Models CAP 232 Zenoah 45cc start
Glens Models CAP 232 Zenoah starting
Переглядів 1624 роки тому
Glens Models CAP 232 Zenoah starting

КОМЕНТАРІ

  • @robwood1904
    @robwood1904 Місяць тому

    What do you think would happen, given the model has ailerons, if you built the wing flat ie no dihedral on the outer panels?

  • @petrokemikal
    @petrokemikal 5 місяців тому

    It will work fine, The reason the hinges seem wrong to you is possibly because your used to the same up and down movment from a horn, like an elevator or rudder.. These horns were probably designed to give max down deflection with very little up, its just a leverage thing, impossible to get a servo to deflect 90 down with a normal horn.. The most you would get would be 45 degrees..once you got past that, it would try and bend the pushrod..

  • @tedf1471
    @tedf1471 5 місяців тому

    CFI "Very amusing Ted - you're grounded!"

  • @keithzhang7194
    @keithzhang7194 Рік тому

    too fast, use slider or throttle stick to do braking normally

  • @scottwheeler1641
    @scottwheeler1641 2 роки тому

    Cool project! Was this a rebuild or kit build engine

    • @philokeefe7960
      @philokeefe7960 2 роки тому

      Rebuild. We think the engine was home built from plans. On the engine the main parts we have replaced are; intake compressor, cold side and hot side shaft bearings and fuel injectors. Started her up this weekend and for the first time spooled up to 160,000 rpm smoothly

  • @skyterrapin
    @skyterrapin 3 роки тому

    Ball links

  • @skyterrapin
    @skyterrapin 3 роки тому

    Whatever deflection you use ....slow the deployment down! 😀

  • @jamesmace254
    @jamesmace254 3 роки тому

    Awesome video I never get to see a md 900

  • @giovannigaibisso831
    @giovannigaibisso831 3 роки тому

    secondo te i servi sono meglio in digitale o analogico per una buona configurazione delAero-Naut LT 200 ?

    • @philokeefe7960
      @philokeefe7960 3 роки тому

      Questo e un modello leggero a volo lento, i servi analogici dovrebbero essere buoni. Se si montassero servi digitali, le prestazioni non cambierebbero. Spero che sia aiuto

  • @crossthreadaeroindustries8554
    @crossthreadaeroindustries8554 3 роки тому

    What does "surpass" get you in the OS 4-stroke. Are the pre-Surpass 4-strokes any good?

  • @ayoaina_fpv
    @ayoaina_fpv 4 роки тому

    Music to me ears!

  • @avilaandrade2197
    @avilaandrade2197 4 роки тому

    What engine used

    • @philokeefe7960
      @philokeefe7960 4 роки тому

      Hi Avila, the engine is the Zenoah 45cc petrol engine. There are a couple of clips on my channel of us starting this engine. Hope this helps!