The Last Carfighter
The Last Carfighter
  • 21
  • 9 663
Jeep TJ third brake light/ high mount brake light missing contact repair
The TJ was missing the lower contact and the connector was in the body, all I saw was an open hole. Using a 3/16 carriage bolt and some spare grommets I was able to repair it in under 5 min.
The grommets specifically came from a Subaru head gasket kit, I’m sure you could use some electrical tape, or cut up some kind of insulating material to achieve similar results.
Переглядів: 49

Відео

OB-4 broken volume “repair”
Переглядів 504Рік тому
Not shown: I pull the knob back off to super glue it to the other half stuck in the motor.
Synthrotek 4093 NAND Handheld jam
Переглядів 652 роки тому
Experimenting with my first DIY synth kit from Synthrotek. Very fun little 3 Oscillator sound generator!
Drone In a Jar
Переглядів 82 роки тому
Rucci’s Handmade light reactive 3 Oscillator Drone! HandmadeElectronicInstruments.com if you would like to check his stuff out. This is a dry signal into this cheap Amazon Bluetooth speaker with LEDS.
Fjording a few puddles in the pine barrens in my '87 Trooper II
Переглядів 183 роки тому
A nice sunday romp through the pine barrens with the boys, first offroad outing in the Trooper. My friend explains how I should approach water after doing it completely wrong. All in all an awesome afternoon.
Suitcase kit
Переглядів 764 роки тому
Suitcase kit
Timmy and Tommy getting in the spirit of the holiday
Переглядів 244 роки тому
Gave me a chuckle this evening
Lady Bird loves Homeward Bound
Переглядів 74 роки тому
Rivited
Keith snapping his left front axle at Rauch Creek 1-12-19
Переглядів 174 роки тому
Good times!
Christmas Surprise for Grampy!
Переглядів 1646 років тому
Merry Christmas, Dad! We surprised him with a watercolor Springer spaniel this year :)
1968 Triumph T100r walk around.
Переглядів 447 років тому
My restored T100r after getting back fromaa Sunday afternoon ride through bucks county.
2009 WRX with Flowmaster Super 44 and Downpipe (catted)
Переглядів 6557 років тому
Car is mostly stock, with K&N Typhoon, Tsuedo 3" catted downpipe, stock midpipe with resonator, and 2.5" center in/ out Flowmaster Super 44. All that was required was 2 2.5" elbows and a 2.5" flange, some rod for hangers, gasket, hardware, and a welder.
Wind Noise and Awkward Camera Angles
Переглядів 128 років тому
Wind Noise and Awkward Camera Angles
1968 Triumph Daytona Super Sport T100r
Переглядів 6 тис.8 років тому
1968 Triumph Daytona Super Sport T100r
Driving Home with New Stinger Exhaust
Переглядів 129 років тому
Driving Home with New Stinger Exhaust
Pulling Out of the Bay
Переглядів 69 років тому
Pulling Out of the Bay
Blown Out Stock Exhaust
Переглядів 409 років тому
Blown Out Stock Exhaust