- 12
- 2 681
SWARBRIX
Приєднався 6 лип 2024
Welcome to Swarbrix. This channel will document work carried out by me on various vehicles. I'm no professional but I've had lots of experience customizing, maintaining and repairing cars and motorbikes over the years yet every day's a school day!
SUZUKI GS 500 Engine installation
The first in a series of videos getting my SUZUKI GS 500 running again after removing the engine to use in an off road buggy. This video shows how I install the engine with a small repair to an engine mount on the frame. Look out for my next videos where I will go through the carbs, brakes, chain whatever it needs to make it fit to ride again. Don't forget to like and subscribe, Enjoy :)
Переглядів: 35
Відео
Ball Joint Replacement DIY MAZDA CX-5
Переглядів 3852 місяці тому
In this video I replace a worn out bottom ball joint on my Mazda CX-5 on my drive with only basic tools. It shows how I removed the lower arm to enable me to hammer out the old ball joint then carefully drive in the new one with a big hammer and a piece of Aluminum pipe. The ball joint cost me £15 and a couple of hours of my time to get the car back on the road.
How I installed a winch and beacons on my sons UTV-MX for his birthday
Переглядів 352 місяці тому
This video shows me installing a manual winch and flashing beacons on my sons UTV-MX for his birthday surprise. Check out my other video on the end screen to see the unveiling and my son playing around with it for the first time.
VR6 Golf Mk3
Переглядів 393 місяці тому
This video shows my VR6 Golf Mk3 which has stood in my garden for fifteen years. If I can get it running again I will transplant the engine into a caddy van. Look out for future videos 👀👍🏻
VW FESTIVAL HAREWOOD HOUSE 10/08/2024
Переглядів 3524 місяці тому
This video shows some of the show cars that turned out at Harewood House today 10/08/2024 Please 👍🏻& subscribe
Stopped my Iveco drop down tipper bed sides from rattling when driving
Переглядів 194 місяці тому
This video shows the solution I came up with to stop my Iveco tipper sides from rattling and it works a treat. See how I did the tailgate in my other videos. Please 👍🏻 & Subscribe. THANKS FOR WATCHING
P0472 Mazda cx5 2.2d Replaced exhaust pressure sensor cured multiple warning lights and no turbo 👍🏻
Переглядів 9254 місяці тому
This video shows the warning lights on my cx5 dash and the installation of a new upgraded exhaust pressure sensor which cured the problem. If you find this video helpful please 👍🏻 & SUBSCRIBE THANKS FOR WATCHING
Mazda cx5 2.2d skyactive 2013 Dash lit up with faults. P0472
Переглядів 3364 місяці тому
This video shows the dash on my cx5 2.2 with multiple fault messages. P0472 code. Look out for the next video and see if a new exhaust sensor cures the problem. Please 👍🏻& Subscribe.
Cheap solution to quiet down rattling tipper bed on Iveco.
Переглядів 124 місяці тому
This video shows a cheap solution to quiet down the tailgate on my Iveco which rattles really loud when driving. Just need to repeat the same on the folding sides. Please 👍🏻 & Subscribe.
PAINTLESS DENT REPAIR (PDR)
Переглядів 984 місяці тому
This video shows me carrying out a PAINTLESS DENT REPAIR (PDR) on my Mazda CX-5. Quite a bad dent with creases. It shows how I accessed behind the wing to push the dents out and how I used a blow torch to gently warm the paint to prevent it from cracking. Please like and subscribe for more DIY. Thanks for watching 👀
Mazda CX5 2.2 Diesel oil/filter change. Service schedule light reset.
Переглядів 725 місяців тому
Mazda CX5 2.2 diesel. Oil/filter change at 158000 miles. Oil changed every 10000 miles. After about 8000 miles after an oil change the Low oil pressure warning sign comes on occasionally which I have been told is due to the oil slowly being diluted with diesel because of the regen system. The new oil seems to stop the warning light reappearing for a few thousand miles. I also show how to reset ...